Express® Lavatory System - MG Series with Battery Infrared Control |
|
Installation Instructions |
Assembly of Components continued . . .
Sensor assembly and solenoid valve access
• To access solenoids:
Using a 5/32" Allen socket wrench, loosen, but do not remove the bottom three access panel screws. Remove the two top access panel screws and washers securing the panel to the frame and remove the access panel (see Figure 3 on page 8). Solenoids are located on left side of frame (see Figure 9).
•To remove sprayhead:
Remove (3) bolts located underside of bowl neck (see Figures 8 and 10). Carefully remove sprayhead from bowl.
•To access sprayhead/aerator/lens and sensor assembly:
Remove (2) screws and washers from the access plate assembly using a 1/8" Allen socket wrench. The access plate assembly is located underneath the sprayhead (2) places (see Figure 11a on page 15), the assembly will drop down to access the lens, sensor, and sensor eyes, housing flow control and tube connector.
FRAME |
5/16" I.D. BRAIDED HOSE |
VERNATHERM™ |
MIXING VALVE |
Figure 9 |
SOLENOIDS |
|
|
|
| SPRAYHEAD AERATOR |
|
|
SPRAYHEAD BODY |
|
| ||||
|
|
|
| |||
|
|
|
|
| ||
|
|
|
| ASSEMBLY |
| |
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
| MOUNTING LOCATION |
|
|
|
| |
Figure 10 |
|
|
| TO BOWL (3) PLACES |
|
|
|
|
|
14 | 8/23/07 | Bradley Corporation • |