HOW TO FINISH UNPACKING
Place packed appliance next to the space in which it will be installed.
Remove the appliance packing except for bottom tray which should be left in position until the appliance is ready to be fitted into its cabinet.
NOTE: It is imperative that the appliance is left in the base to protect both the appliance and the floor.
Ensure the owner is given these operating instructions.
Important: Switch off at mains, miniature circuit breaker and, if appropriate, remove fuse before commencing any electrical work.
TO REMOVE COVER OF MAINS TERMINAL
From the rear of the appliance, remove mains input terminal cover to gain access to terminal block.
First remove retaining screw with pozidrive screwdriver. See Fig. 8.
Prise cover loose using screwdriver in position
(1)then lever off with screwdriver in position (2) at either side. See Fig. 9.
Lift cover and remove screw from cable clamp. See Fig. 10.
Fig. 8
Fig.9
Fig.10
45