KitchenAid BUILT-IN REFRIGERATOR manual Ice Maker and Storage Bin

Page 10

A new water filter should display a reading of 99% and will continue to decrease as the filter life is used. When display reads 10%, it is time to order a replacement filter. It is recommended that you replace the base grille water filter cartridge when the water filter indicator light changes to 0% OR when water flow to your water dispenser or ice maker decreases noticeably. See “Changing the Base Grille Filter.”

After changing the water filter cartridge, reset the water filter status light by pressing and holding the RESET button for

2 seconds. The indicator light will change to 99% when the filter indicator is reset.

Changing the Base Grille Filter

1.Locate the water filter cartridge cap in the front base grille. Rotate the cap counterclockwise to a vertical position and pull the cap and filter cartridge out through the base grille.

NOTE: There will be water in the cartridge. Some spilling may occur.

2.Remove the cartridge cap by sliding it off the end of the old cartridge. The cap will slide to the left or right.

IMPORTANT: Do not discard the cartridge cap. It is part of your refrigerator. Keep the cartridge cap to use with the replacement filter.

3.Take the new cartridge out of its packaging and remove protective cover from o-rings. Discard the protective cover.

4.Slide the cartridge cap onto the new cartridge. See illustration in Step 2.

5.With cartridge cap handle in the vertical position, push the new filter cartridge into the base grille until it stops. Rotate the cartridge cap clockwise to a horizontal position. Flush the water system. See “Flushing the Water System After Replacing Filter.”

Flushing the Water System After Replacing Filter

Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 6 qt. (5.7 L) of water. Cleaning the system will take approximately 3 to 4 minutes and will help clear air from the line. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

Using the Dispenser Without the Water Filter

You can run the dispenser without a water filter cartridge. Your water will not be filtered.

1.Remove the base grille water filter cartridge.

2.Slide the cartridge cap off the end of the filter cartridge. With the cartridge cap handle in the vertical position, insert the cartridge cap into the base grille until it stops.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

3.Rotate the cartridge cap to a horizontal position. The cartridge cap might not be even with the base grille.

Ice Maker and Storage Bin

(on some models - Accessory)

Style 1

To turn the ice maker on/off:

The on/off switch for the ice maker is a wire shutoff arm located on the side of the ice maker.

1.To turn the ice maker on, simply lower the wire shutoff arm.

NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position.

2.To manually turn the ice maker off, lift the wire shutoff arm to the OFF (arm up) position and listen for the click to make sure the ice maker will not continue to operate.

To increase ice production rate:

In normal ice production, the ice maker should produce approximately 7 to 9 batches of ice in a 24-hour period. If ice is not being made fast enough, turn the Freezer Control toward a higher (colder) number. Wait 24 hours between each increase.

10

Image 10
Contents Table of Contents/Índice/Table des matières Side by Side BUILT-IN RefrigeratorÍndice Refrigerator Safety Before you throw away your old refrigerator or freezerRefrigerator USE Power On/Off SwitchBefore USE Water Supply RequirementsTo replace top grille To Turn Power On or OffClassic, Overlay and Complete Series To remove top grille Architect Series To remove top grilleEnsuring Proper Air Circulation Water System PreparationNormal Sounds Style 1 Non-Dispenser Models Style 2 Dispenser ModelsUsing Controls Water and Ice Dispensers Water Filtration System Ice Maker and Storage Bin Refrigerator Shelves Refrigerator FeaturesClean the ice storage bin To remove and replace the ice binCrisper and Covers Ingredient Care CenterCovered Utility Bin Wine Rack Freezer Basket Freezer Featuresdoor FeaturesFreezer Shelf Utility CompartmentRefrigerator Care CleaningTo clean your refrigerator Changing the Light BulbsPower Interruptions Vacation CareTroubleshooting Ice bin difficult to remove Off-taste, odor or gray color in the iceIce dispenser will not operate properly Water dispenser will not operate properlyAssistance or Service U.S.AWater Filter Certifications AccessoriesCanada Product Data Sheets Application Guidelines/Water Supply ParametersLifetime Limited Warranty on Door Bins Kitchenaid BUILT-IN Refrigerator WarrantyTWO-YEAR Full Warranty KitchenAid will not pay forSeguridad DEL Refrigerador Antes de tirar su refrigerador o congelador viejoRequisitos del suministro de agua Antes DE UsarUSO DE SU Refrigerador Interruptor de Encendido/ApagadoSerie Pro Line Para quitar la rejilla superior Para volver a colocar la rejilla superiorSerie Architect Para quitar la rejilla superior Para encender o apagarEstilo 1 Modelos sin despachador Preparación del sistema de aguaSonidos normales Estilo 2 Modelos con despachadorPara ver las temperaturas en centígrados Uso de los controlesPara conectar el refrigerador y ver los puntos de ajuste Ajuste de los controlesOver Temperature Temperatura excesiva Holiday Mode Modo de día de fiestaFunciones de alarma Restablecimiento de la alarma maestra Estado del filtro de agua y reajusteDoor Open Puerta abierta Call Service Solicite servicioDespachadores de agua y hielo El despachador de hieloSistema de filtración de agua Estilo Cómo encender y apagar la fábrica de hielo Fábrica de hielo y depósitoUso del despachador sin el filtro de agua Cómo incrementar la producción de hieloCómo limpiar el depósito o balde de hielo Cómo quitar y volver a colocar el depósito de hieloEstilo Para quitar y volver a colocar el balde de hieloCentro de cuidado de ingredientes Características DEL RefrigeradorEstantes del refrigerador Cómo ajustar el centro de cuidado de ingredientesCaracterísticas DEL Congelador Compartimiento utilitario Características DE LA PuertaCuidado DE SU Refrigerador Recipientes de las puertasLuz del panel de control del refrigerador Estilo Cómo cambiar los focosLuz del despachador en algunos modelos Luces del congeladorCortes de corriente Solución DE ProblemasCuidado durante las vacaciones El hielo tiene mal sabor, mal olor o un color grisáceo El refrigerador parece hacer mucho ruidoEl despachador de hielo no funciona debidamente El despachador de agua no funciona debidamente El balde de hielo es difícil de sacarHay filtración de agua o hielo en el despachador La temperatura está demasiado caliente El agua del despachador no está lo suficientemente fríaEl divisor entre los dos compartimientos está caliente Hay acumulación de humedad en el interiorEn los EE.UU Ayuda O Servicio TécnicoEn Canadá AccesoriosHoja DE Datos DEL Producto Pautas de aplicación/Parámetros para el suministro de aguaGarantía Total DE DOS Años EN EL Refrigerador KitchenAid no pagará porSécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurUtilisation DU Réfrigérateur Avant L’UTILISATIONSpécifications de l’alimentation en eau Série Architect Pour enlever la grille supérieure Réinstallation de la grille supérieureCommutateur marche/arrêt Série Pro Line Pour enlever la grille supérieurePour s’assurer d’une Circulation d’air appropriée Préparation du système d’eauSons normaux RemarquesPour voir les températures en Celsius Utilisation des commandesAjustement des commandes Pour ajuster les points de réglage de températureÉtat et réinitialisation du filtre à eau Holiday Mode mode vacancesFonctions dalarme Réinitialisation de lalarme principale Max Cool refroidissement maximalDistributeurs d’eau et de glaçons Over temperature dépassement de la températureCall Service appel de service Door Open porte ouverteSystème de filtration deau Machine à glaçons et bac/seau d’entreposage Remplacement du filtre dans la grille de la basePurge du système d’eau après le remplacement du filtre Utilisation du distributeur sans filtre à eauStyle Mise en marche/ arrêt de la machine à glaçons Pour retirer et réinstaller le bac à glaçonsAugmentation du taux de production de glaçons Pour retirer et réinstaler le seau à glaceCentre de soins des ingrédients Caractéristiques DU RéfrigérateurTablettes du réfrigérateur Réglage du centre de soin des ingrédientsCaractéristiques DU Congélateur Compartiment utilitaire PorteEntretien DU Réfrigérateur Compartiments dans la porteRemplacement des ampoules d’éclairage Lampe de distributeur sur certains modèlesEntretien avant les vacances Lampe du tableau de commande du réfrigérateur StylePannes de courant Lampes du congélateur et du bac à légumesDépannage Le distributeur de glaçons ne fonctionne pas correctement Mauvais goût, odeur ou couleur grise des glaçonsLe seau à glaçons est difficile à enlever Le débit d’eau du distributeur diminue beaucoup Le distributeur d’eau ne fonctionne pas bienDe l’eau ou de la glace coule du distributeur ’eau du distributeur n’est pas assez froideAssistance OU Service AccessoiresFeuilles DE Données SUR LE Produit Système de filtration d’eau à la grille de la baseGarantie Limitée À VIE SUR LES Compartiments Dans LA Porte Garantie Complète DE Deux ANSKitchenAid ne paiera pas pour 2309068 All rights reserved

BUILT-IN REFRIGERATOR specifications

The KitchenAid Built-In Refrigerator is a blend of style, functionality, and advanced technology tailored for modern kitchens. Engineered to fit seamlessly into your cabinetry, this refrigerator not only enhances the aesthetic appeal of your kitchen but also offers outstanding performance. With its flush installation and customizable panel options, it can match the look of your cabinets, creating a cohesive design that elevates your culinary space.

One of the standout features of the KitchenAid Built-In Refrigerator is its advanced cooling system. It incorporates a dual cooling system that ensures optimal temperature and humidity levels for both the refrigerator and freezer compartments. This technology prevents the transfer of odors and ensures fresh, flavorful food preservation. The refrigerator also features a Produce Preserver, which utilizes ethylene gas-absorbing packets to delay over-ripening of fruits and vegetables, helping to extend their freshness.

Additionally, this model is equipped with an In-Door-Ice System, which maximizes usable shelf space while providing easy access to ice. The system is designed to keep ice readily available without impinging on the storage capabilities of the refrigerator. With its sleek design, the refrigerator also includes a water dispenser that provides filtered water at the touch of a button, further enhancing convenience.

Another technological advancement in the KitchenAid Built-In Refrigerator is the Smart Feature compatibility. With Wi-Fi connectivity, users can monitor and manage the refrigerator remotely using their smartphones. This feature allows for the adjustment of temperature settings and even alerts when the door is left open, ensuring food safety.

Energy efficiency is also a priority with this model. The KitchenAid Built-In Refrigerator is designed to meet ENERGY STARĀ® guidelines, helping consumers save on electricity bills while minimizing environmental impact. With a focus on durability and performance, this refrigerator boasts a robust stainless-steel finish, making it resistant to fingerprints and easy to clean.

In summary, the KitchenAid Built-In Refrigerator is an exceptional choice for those seeking a high-end appliance that combines style, innovative features, and energy efficiency. Its smart technologies, advanced cooling capabilities, and customizable options make it a must-have for discerning homeowners looking to enhance their kitchen experience.