KitchenAid 2308307 manual Adjustthe Doors, Remove the Doors, Replace the Doors and Hinges

Page 7

 

4. Align and replace the top left hinge as shown in Graphic 3.

Remove the Doors

Tighten screws.

 

 

WARNING

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

1.Unplug refrigerator or disconnect power.

2.Open both refrigerator doors. Remove the base grille by pulling up on the bottom outside corners. See Graphic 1.

3.Close both doors and keep them closed until you are ready to lift them free from the cabinet.

4.If you have a dispenser (ice or water), disconnect the water dispenser tubing located behind the base grille on the freezer door side. See Graphic 2.

■Press the red outer ring against the face of fitting and pull the dispenser tubing free.

■On some models, remove tubing from hose clip.

5.Remove top left hinge screw and cover as shown in Graphic 3.

6.Disconnect wiring plug and both ground wires from the ground wire screw (on some models) as shown in Graphic 3.

7.Remove remaining left hinge screws and hinge as shown in Graphic 3. Do not remove screw A.

8.Lift freezer door straight up off bottom hinge. See Graphic 4. The water dispenser tubing remains attached to the freezer door and pulls through the bottom left hinge. Make sure you protect the dispenser tubing from damage.

9.Remove top right hinge cover and screws as shown in Graphic 5. Do not remove screw A.

10.Lift the refrigerator door straight up off bottom hinge.

11.It may not be necessary to remove the bottom hinge to move the refrigerator through a doorway. Both bottom hinges have similar construction.

■Disassemble the hinges as shown in Graphic 6. Do not remove screw A.

Replace the Doors and Hinges

1.Replace both bottom hinges, if removed. Tighten screws.

2.Assistance may be needed to feed the water dispenser tubing through the bottom hinge while reinstalling the freezer door. Feed the dispenser tubing through the bottom left hinge before replacing the door on the hinge.

NOTE: Provide additional support for the doors while the top hinges are being replaced. Do not depend on the door magnets to hold the doors in place while you are working.

3.Reconnect water dispenser tubing by pushing tubing into fitting until it stops and black mark touches the face of the red outer ring. See Graphic 2. On some models, replace tubing in hose clip.

WARNING

Electrical Shock Hazard

Reconnect both ground wires.

Failure to do so can result in death or electrical shock.

Style 1

■Reconnect both ground wires.

■Reconnect wiring plug.

C

D

A

B

A. Do not remove screw A

B. Ground wires

C. Green ground wire screw

D. Wiring plug

Style 2

■ Reconnect wiring plug.

5.Replace left hinge cover and screws.

6.Replace the refrigerator door by lifting the door onto the bottom right hinge.

7.Align and replace the top right hinge as shown in Graphic 5. Tighten screws.

8.Replace hinge cover and screws. Tighten screws.

9.Plug into a grounded 3 prong outlet.

Adjustthe Doors

Your refrigerator has two front adjustable rollers — one on the right and one on the left. If your refrigerator seems unsteady or if you want the doors to close more easily, adjust the refrigerator's tilt using the instructions below.

WARNING

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

1.Move the refrigerator into its final position.

2.The two leveling screws are part of the front roller assemblies which are at the base of the refrigerator on either side. See Graphic 7.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Side by Side Refrigerator Table of Contents/Table des matièresTable DES Matières Table of ContentsBefore you throw away your old refrigerator or freezer Refrigerator SafetyLocation Requirements Installation InstructionsClean Before Using Unpack the RefrigeratorWater Supply Requirements Electrical RequirementsBase Grille Refrigerator Doors Remove the Doors Adjustthe DoorsReplace the Doors and Hinges Connect to Water Line Connectthe Water SupplyConnect to Refrigerator Style On some models Complete the InstallationPrepare the Water System FactoryTrimKitReplace the Door Panels Install Custom Wood PanelsDimensions for Custom Wood Panels Remove the Door PanelsEnsuring Proper Air Circulation Usingthe ControlsDimensions for Routing Handle Side of Door Panel End View Refrigerator USEWater Filter Indicator Light and Reset Adjusting Slide ControlsAdjusting Electronic Controls Additional Electronic Control Panel FeaturesAccelerated Ice Production Adjusting Digital ControlsAdditional Digital Control Panel Features Temperature SystemWater and Ice Dispensers Changing the Water Filter Cartridge WaterFilter Status LightWaterFiltration System Dispenser Lock on some modelsIce Maker and Storage Bin On some models -AccessoryConvertible Vegetable/MeatDrawer Crisper and Covers Refrigerator FeaturesRefrigerator Shelves DeliDrawerFreezer Features Door Features DoorAir Control CleaningTo Clean Your Refrigerator Refrigerator CareChanging the Light Bulbs Power InterruptionsVacation and MovingCare TroubleshootingIce maker is not producing ice or not enough ice Motor seems to run too muchOff-taste, odor or gray color in the ice Refrigerator seems to make too much noiseWater or ice is leaking from the dispenser Temperature is too warmIce storage bin difficult to remove Water dispenser will not operate properlyCanada Assistance or ServiceAccessories TheU.S.AWater Filter Certifications Base Grille Water Filtration System Product Data SheetsKitchenAid or KitchenAid Canada will not pay for Kitchenaid Refrigerator WarrantyONE-YEAR Full Warranty on Refrigerator Lifetime Limited Warranty on Door Bins and can RacksPage Avant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurEnlèvement des matériaux demballage Instructions D’INSTALLATIONEmplacement d’installation Déballage du réfrigérateurSpécifications de l’alimentation en eau Spécifications électriquesGrille de la base Portesdu réfrigérateur Enlever les portes Remplacer les portes et les charnièresRaccordement au réfrigérateur Style Ajuster lesportesRaccordementde la canalisation d’eau Raccordement à une canalisation d’eauRemarques Achever l’installationPréparerlesystème deau Veuillez lire avant d’utiliser le système d’eauSur certains modèles Ensembles décoratifs de l’usinePorte du congélateur et réfrigérateur de 25 pi cu Dimensions pour les panneaux en bois personnalisésSons normaux Porte du congélateur et réfrigérateur de 22 pi cuUtilisation DU Réfrigérateur Utilisation des commandesCommandes à curseur sur certains modèles Ajustement des commandes à curseurCommandes numériques sur certains modèles Commandes électroniques sur certains modèlesAutres caractéristiques du tableau de commande électronique Ajustement des commandes électroniquesDistributeurs d’eau et de glaçons Distribution d’eau Le distributeur d’eauLumière du distributeur Style Distribution de glaçonsSystème de filtration d’eau Remplacement du filtre à eauDistributeur Tableau de commande Le témoin lumineux de l’état du filtre à eauMachineàglaçons et bacd’entreposage Sur certains modèles- accessoireTiroir pour spécialités alimentaires Caractéristiques DU RéfrigérateurTablettesdu réfrigérateur Casier utilitaire Sur certainsmodèles -AccessoireRéglage de l’humidité dansle bac à légumes CasieràvinCaractéristiques DE LA Porte Caractéristiques DU CongélateurPorte-cannettes et balconnets Commande dair de la porteEntretien DU Réfrigérateur Tringles déposéesdansla porteLampe du bac à légumes Remplacementdes ampoulesd’éclairageLampe du tableau de commande du réfrigérateur Lampe de distributeur sur certains modèlesDéménagement Pannes de courantEntretien avant les vacances ou lors ’un déménagement Style 2 En arrière du panier du congélateurDépannage Minutes initialement. Jeter la glace décolorée Mauvais goût, odeur ou couleur grise des glaçonsLe distributeur de glaçons ne fonctionne pas correctement Le bac à glaçons est difficile à enlever’eau du distributeur n’est pas assez froide Le distributeur d’eau ne fonctionne pas bien’eau ou la glace coule du distributeur Le débit d’eau du distributeur diminue beaucoupAccessoires Assistance OU ServiceSystème de filtration d’eau à la grille de la base Feuilles DE Données SUR LE Produit2308307 Garantie DU Réfrigérateur KitchenaidGarantie Complète DE UN AN SUR LE Réfrigérateur KitchenAid ou KitchenAid Canada ne paiera pas pour

2308307 specifications

The KitchenAid 2308307 is an innovative and versatile stand mixer that has captured the hearts of home bakers and culinary enthusiasts around the world. Known for its durability and performance, this model stands out with an impressive blend of features and technologies designed to enhance the home cooking experience.

One of the standout characteristics of the KitchenAid 2308307 is its powerful 300-watt motor. This robust motor allows the mixer to handle a wide variety of tasks, from mixing light batters to kneading heavy dough, making it an ideal companion for all baking endeavors. The motor is also designed to operate quietly, providing a more pleasant kitchen experience.

The mixer boasts a unique tilt-head design, which offers easy access to the mixing bowl. This feature allows users to easily add ingredients and scrape the sides of the bowl without any hassle, leading to more efficient baking. The included 4.5-quart stainless steel mixing bowl is both durable and resistant to rust, ensuring long-lasting performance.

This model comes with three essential attachments: a flat beater, a dough hook, and a wire whip. Each attachment is designed to tackle specific tasks, whether it’s mixing ingredients, kneading dough, or whipping cream. The versatility of these attachments expands the mixer's functionality, allowing users to create a wide range of recipes with ease.

In terms of technology, the KitchenAid 2308307 features a 10-speed slide control, enabling precision mixing. Users can select the perfect speed for their specific task, whether it’s folding in delicate ingredients or achieving a robust mix. This range of speeds allows for complete control over the mixing process, catering to both novice cooks and seasoned bakers.

Another important characteristic is the dishwasher-safe bowl and attachments, which makes cleanup quick and effortless. The sleek design and variety of color options also ensure that the KitchenAid mixer fits beautifully into any kitchen decor.

In conclusion, the KitchenAid 2308307 combines functionality, durability, and user-friendly features to create a stand mixer that is not only effective but also aesthetically pleasing. Ideal for a diverse range of culinary tasks, this stand mixer is a worthwhile investment for anyone looking to elevate their baking game. Whether preparing simple dessert mixtures or complex bread recipes, this mixer is equipped to handle it all with style and efficiency.
Top Page Image Contents