KitchenAid 2308307 manual Prepare the Water System, FactoryTrimKit, On some models

Page 9

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug in refrigerator or reconnect power.

2.Flush the water system. See “Prepare the Water System.”

NOTE: It may take up to 24 hours for your ice maker to begin producing ice.

Prepare the Water System

Please read before using the water system.

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Open the freezer door and turn off the ice maker. For Style 1, lift up the wire shutoff arm as shown. For Style 2, move the switch to the OFF (right) setting as shown. The ON/OFF switch is located on the top right side of the freezer compartment.

Style 1

Style 2

NOTES:

■If your model has a base grille filter system, make sure the base grille filter is properly installed and the cartridge cap handle is in the horizontal position.

■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

2.Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 2 to 3 gal. (8 to 12 L) of water. Cleaning the system will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

3.Open the freezer door and turn on the ice maker. For Style 1, lower the wire shutoff arm. For Style 2, move the switch to the ON (left) position. Please refer to the “Ice Maker and Storage Bin” section for further instructions on the operation of your ice maker.

■Allow 24 hours to produce the first batch of ice.

■Discard the first three batches of ice produced.

■Depending on your model, you may want to select the maximum ice feature to increase the production of ice.

FactoryTrimKit

(on some models)

There may be an occasion when you will need to remove the factory-installed trim kit, such as moving the refrigerator to a new home or installing custom-made decorator panels. Please read all instructions before removing the trim kit and decorator panels.

Freezer Door

Refrigerator Door

B A

C

B A

A

B

A. Decorator panels

B. Filler panels

C. Handles

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Side by Side Refrigerator Table of Contents/Table des matièresTable DES Matières Table of ContentsBefore you throw away your old refrigerator or freezer Refrigerator SafetyClean Before Using Installation InstructionsUnpack the Refrigerator Location RequirementsElectrical Requirements Water Supply RequirementsBase Grille Refrigerator Doors Adjustthe Doors Remove the DoorsReplace the Doors and Hinges Connectthe Water Supply Connect to Water LineConnect to Refrigerator Style Prepare the Water System Complete the InstallationFactoryTrimKit On some modelsDimensions for Custom Wood Panels Install Custom Wood PanelsRemove the Door Panels Replace the Door PanelsDimensions for Routing Handle Side of Door Panel End View Usingthe ControlsRefrigerator USE Ensuring Proper Air CirculationAdjusting Electronic Controls Adjusting Slide ControlsAdditional Electronic Control Panel Features Water Filter Indicator Light and ResetAdditional Digital Control Panel Features Adjusting Digital ControlsTemperature System Accelerated Ice ProductionWater and Ice Dispensers WaterFiltration System WaterFilter Status LightDispenser Lock on some models Changing the Water Filter CartridgeIce Maker and Storage Bin On some models -AccessoryRefrigerator Shelves Refrigerator FeaturesDeliDrawer Convertible Vegetable/MeatDrawer Crisper and CoversFreezer Features Door Features To Clean Your Refrigerator CleaningRefrigerator Care DoorAir ControlChanging the Light Bulbs Power InterruptionsVacation and MovingCare TroubleshootingOff-taste, odor or gray color in the ice Motor seems to run too muchRefrigerator seems to make too much noise Ice maker is not producing ice or not enough iceIce storage bin difficult to remove Temperature is too warmWater dispenser will not operate properly Water or ice is leaking from the dispenserAccessories Assistance or ServiceTheU.S.A CanadaWater Filter Certifications Base Grille Water Filtration System Product Data SheetsONE-YEAR Full Warranty on Refrigerator Kitchenaid Refrigerator WarrantyLifetime Limited Warranty on Door Bins and can Racks KitchenAid or KitchenAid Canada will not pay forPage Avant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurEmplacement d’installation Instructions D’INSTALLATIONDéballage du réfrigérateur Enlèvement des matériaux demballageSpécifications électriques Spécifications de l’alimentation en eauGrille de la base Portesdu réfrigérateur Enlever les portes Remplacer les portes et les charnièresRaccordementde la canalisation d’eau Ajuster lesportesRaccordement à une canalisation d’eau Raccordement au réfrigérateur StylePréparerlesystème deau Achever l’installationVeuillez lire avant d’utiliser le système d’eau RemarquesSur certains modèles Ensembles décoratifs de l’usineSons normaux Dimensions pour les panneaux en bois personnalisésPorte du congélateur et réfrigérateur de 22 pi cu Porte du congélateur et réfrigérateur de 25 pi cuCommandes à curseur sur certains modèles Utilisation des commandesAjustement des commandes à curseur Utilisation DU RéfrigérateurAutres caractéristiques du tableau de commande électronique Commandes électroniques sur certains modèlesAjustement des commandes électroniques Commandes numériques sur certains modèlesDistributeurs d’eau et de glaçons Lumière du distributeur Style Le distributeur d’eauDistribution de glaçons Distribution d’eauDistributeur Tableau de commande Remplacement du filtre à eauLe témoin lumineux de l’état du filtre à eau Système de filtration d’eauMachineàglaçons et bacd’entreposage Sur certains modèles- accessoireCaractéristiques DU Réfrigérateur Tiroir pour spécialités alimentairesTablettesdu réfrigérateur Réglage de l’humidité dansle bac à légumes Sur certainsmodèles -AccessoireCasieràvin Casier utilitaireCaractéristiques DE LA Porte Caractéristiques DU CongélateurEntretien DU Réfrigérateur Commande dair de la porteTringles déposéesdansla porte Porte-cannettes et balconnetsLampe du tableau de commande du réfrigérateur Remplacementdes ampoulesd’éclairageLampe de distributeur sur certains modèles Lampe du bac à légumesEntretien avant les vacances ou lors ’un déménagement Pannes de courantStyle 2 En arrière du panier du congélateur DéménagementDépannage Le distributeur de glaçons ne fonctionne pas correctement Mauvais goût, odeur ou couleur grise des glaçonsLe bac à glaçons est difficile à enlever Minutes initialement. Jeter la glace décolorée’eau ou la glace coule du distributeur Le distributeur d’eau ne fonctionne pas bienLe débit d’eau du distributeur diminue beaucoup ’eau du distributeur n’est pas assez froideAccessoires Assistance OU ServiceSystème de filtration d’eau à la grille de la base Feuilles DE Données SUR LE ProduitGarantie Complète DE UN AN SUR LE Réfrigérateur Garantie DU Réfrigérateur KitchenaidKitchenAid ou KitchenAid Canada ne paiera pas pour 2308307

2308307 specifications

The KitchenAid 2308307 is an innovative and versatile stand mixer that has captured the hearts of home bakers and culinary enthusiasts around the world. Known for its durability and performance, this model stands out with an impressive blend of features and technologies designed to enhance the home cooking experience.

One of the standout characteristics of the KitchenAid 2308307 is its powerful 300-watt motor. This robust motor allows the mixer to handle a wide variety of tasks, from mixing light batters to kneading heavy dough, making it an ideal companion for all baking endeavors. The motor is also designed to operate quietly, providing a more pleasant kitchen experience.

The mixer boasts a unique tilt-head design, which offers easy access to the mixing bowl. This feature allows users to easily add ingredients and scrape the sides of the bowl without any hassle, leading to more efficient baking. The included 4.5-quart stainless steel mixing bowl is both durable and resistant to rust, ensuring long-lasting performance.

This model comes with three essential attachments: a flat beater, a dough hook, and a wire whip. Each attachment is designed to tackle specific tasks, whether it’s mixing ingredients, kneading dough, or whipping cream. The versatility of these attachments expands the mixer's functionality, allowing users to create a wide range of recipes with ease.

In terms of technology, the KitchenAid 2308307 features a 10-speed slide control, enabling precision mixing. Users can select the perfect speed for their specific task, whether it’s folding in delicate ingredients or achieving a robust mix. This range of speeds allows for complete control over the mixing process, catering to both novice cooks and seasoned bakers.

Another important characteristic is the dishwasher-safe bowl and attachments, which makes cleanup quick and effortless. The sleek design and variety of color options also ensure that the KitchenAid mixer fits beautifully into any kitchen decor.

In conclusion, the KitchenAid 2308307 combines functionality, durability, and user-friendly features to create a stand mixer that is not only effective but also aesthetically pleasing. Ideal for a diverse range of culinary tasks, this stand mixer is a worthwhile investment for anyone looking to elevate their baking game. Whether preparing simple dessert mixtures or complex bread recipes, this mixer is equipped to handle it all with style and efficiency.
Top Page Image Contents