KitchenAid KUDD01DP Delay Start mode, To activate the Delay Start, To cancel the Delay Start

Delay Start mode

The start of the selected wash cycle can be delayed from 1 to 12 hours.

To activate the Delay Start

1.Press and hold the Start/Pause button until the light above turns orange or lavender depending on model.

2.The dishwasher will beep as you hold down the button. Each “beep” represents an hour delay, so for each beep while the button is pressed an additional hour delay will be programmed until the desired delay time is reached.

3.Make sure the drawer is closed.

4.The dishwasher will start after the set delay time has elapsed.

To cancel the Delay Start

1.Press the Power button to turn off the dishwasher or hold the Start/Pause button until the light turns green or blue (depending on model).

OR

Power button Start/Pause button

To enter the Option Adjustment Mode

1.Press the Power button to turn the dishwasher to the Normal Operating Mode.

2.Press and hold the HI TEMP and Lock buttons at the same time for 5 seconds. When the buttons have been correctly pressed, one long beep is sounded and the Start/Pause light is red.

3.Release the HI TEMP and lock buttons.

4.Use the appropriate buttons on the control panel to make the necessary adjustments. These are explained below.

5.Once the changes have been made, press the Power button to return to the Normal Operating Mode.

NOTE: The dishwasher automatically saves these changes.

To adjust the Rinse Aid setting

NOTE: If there is excessive foam at the end of the wash, reduce the rinse aid dispenser setting. If dishes are wet or streaky after drying, increase the rinse aid dispenser setting. (See “How much rinse aid to use.”)

1.Enter the Option Adjustment Mode as explained above. The light above the Start/Pause button is red to indicate this setting has been chosen.

2.The current Rinse Aid setting is shown on the wash cycle indicator panel. The number of red lights lit on the panel shows what the current rinse aid setting is. For example, if 4 red lights are lit on the panel, then the Rinse Aid setting is at 4.

HEAVY NORMAL QUICK LIGHT/ RINSE

CLEAN CHINA

Example of Rinse Aid setting at 4

3.Press the Lock button to increase or decrease the Rinse Aid setting, the red lights will scroll up to 5 and then start from 1 again.

4.Once you have selected the desired Rinse Aid setting, press the Power button to return to the Normal Operating Mode.

To remove the Auto Power setting

When the dishwasher leaves the factory, it is programmed to automatically power up whenever the drawer is opened even if the Power pad has not been pressed. The dishwasher will not start washing until the drawer is closed and the Start/Pause button has been pressed. If you do not want the dishwasher to automatically power up, this feature can be turned off.

1.Enter the Option Adjustment Mode as explained at the beginning of this section.

2.Press the Start/Pause button until the light above is orange or lavender (depending on model), and the light above the

HI TEMP button is red. If it is not, press the Power button to return to Normal Operating Mode and start again.

3.Press the Lock button to turn the Auto Power feature on or off. If all the red lights on the wash cycle panel are off, then the Auto Power feature has been turned off.

4.Press the Power button to return to the Normal Operating Mode.

Auto Power On	HEAVY NORMAL QUICK	LIGHT/	RINSE
	CLEAN	CHINA
Auto Power Off	HEAVY NORMAL QUICK	LIGHT/	RINSE
	CLEAN	CHINA

13