Hotpoint RB632 Surface Units, Drip Pans, To remove a surface unit, To replace a surface unit

Page 23

Be sure all the controls are turned to OFF and the surface units are cool before attempting to remove them.

Surface unit

 

 

Surface Units

 

 

To clean the surface units, turn the control to the highest

 

 

 

 

 

 

 

 

setting for a minute. The coils will burn off any soil.

 

 

 

 

To remove a surface unit:

 

 

 

 

To remove the drip pans for cleaning, the surface units

 

 

Drip pan

must be removed first.

Receptacle

 

 

 

Lift the surface unit about 1 inch above the drip pan and

 

 

 

 

 

 

 

 

 

 

 

 

pull it out.

 

 

 

 

Do not lift the surface unit more than 1 inch. If you do, it may not lie

 

 

 

 

flat on the drip pan when you plug it back in.

 

 

 

 

Repeated lifting of the surface unit more than 1 inch above

 

 

 

 

the drip pan can permanently damage the receptacle.

 

 

 

 

To replace a surface unit:

 

 

 

 

Replace the drip pan into the recess in the cooktop. Make

 

 

 

 

sure the opening in the pan lines up with the receptacle.

 

 

 

 

Insert the terminals of the surface unit through the

 

 

 

 

opening in the drip pan and into the receptacle.

 

 

 

 

Guide the surface unit into place so it rests evenly.

 

 

 

 

Do not immerse the surface units in liquids of any kind.

 

 

 

 

 

 

 

 

Do not clean the surface units in a dishwasher.

 

 

 

 

Do not bend the surface unit plug terminals.

 

 

 

 

 

 

 

 

Do not attempt to clean, adjust or in any way repair the plug-in

 

 

 

 

receptacle.

Drip Pans

Remove the surface units. Then lift out the drip pans.

For best results, clean the drip pans by hand. Place them in a covered container (or a plastic bag) with 1/4 cup ammonia to loosen the soil. Then scrub with a soap-filled scouring pad if necessary. Rinse with clean water and polish with a clean soft cloth.

The drip pans may also be cleaned in the dishwasher.

Clean the area under the drip pans often. Built-up soil, especially grease, may catch fire.

Do not cover the drip pans with foil. Using foil so close to the receptacle could cause shock, fire or damage to the range.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

23

Image 23
Contents Ranges Write the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the Hotpoint Family Hotpoint & You Service Partnership All ranges can tip and injury could result Important Safety NoticeSafety Precautions Safety Information When Cooking PORK… Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsWok Cooking Using the surface unitsHow to Set Surface Cookware TipsClock and Timer Features Using the clock and timerTo Set the Clock To Set the TimerTo Reset the Timer To Cancel the TimerBefore you begin… Using the ovenOven Temperature Knob Customer Service TroubleshootingAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Comments Broiling guideTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfPainted Surfaces Care and cleaning of the rangeControl Panel and Knobs Oven VentLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door To remove the cover Oven Light Replacement on some modelsOven Heating Elements Oven ShelvesTo replace the storage drawer How to Remove the Storage Drawer to Clean Under the RangeBroiler Pan & Grid To remove the storage drawerLift-Up Cooktop on some models Porcelain Enamel CooktopTo replace a surface unit Surface UnitsDrip Pans To remove a surface unitContinuous-cleaning oven cleans itself while cooking Let the range parts cool before handling To Clean the Continuous-Cleaning OvenPorcelain Oven Interior on some models Before You Begin Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationWire Power Cord Installation Before After Wire Conduit Installation Conduit Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Broil properly At Broil Food does not bakeOr roast properly Food does notToo hot or too cold Oven temperatureClock and timer Power outageOne Year Hotpoint Range WarrantyWe Will Replace, At No Charge To You TDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES
Related manuals
Manual 40 pages 55.5 Kb