Hotpoint RB536, RB533, RB526, RB632, RB525 owner manual Before After

Page 32

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

5 4-Wire Power Cord Installation

WARNING: The neutral wire of the supply circuit is connected to the neutral terminal located in the center of the connector block. The power leads must be connected to the outside (brass colored) terminals. The 4th grounding lead must be connected

to the frame of the range with the grounding plate and grounding screw.

a Remove the 3 screws from the connector block.

	b	Remove the grounding screw and strap from the connector block middle
	b	location and the screw connection to the frame of the range.

		Insert screws through each power cord terminal ring and into connector
	c
	c	block until screw engages nut. Be certain that the center wire is connected

		to the center screw of the connector block. Tighten screws securely.
		Attach ground wire to the frame of the range.
	d	Attach ground wire to the frame of the range.
		Before			After
			Neutral terminal		Neutral terminal
					Grounding
				Ground Strap	plate
				Ground Strap
				(grounding to range)	Grounding to range
					Grounding to range

32

Image 32

Contents Ranges Write the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the Hotpoint Family Hotpoint & You Service Partnership Important Safety Notice All ranges can tip and injury could resultSafety Precautions Safety Information When Cooking PORK… Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Using the surface units How to SetSurface Cookware Tips Wok CookingUsing the clock and timer Clock and Timer FeaturesTo Set the Timer To Reset the TimerTo Cancel the Timer To Set the ClockUsing the oven Oven Temperature KnobCustomer Service Troubleshooting Before you begin…Aluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Broiling guide CommentsAdjust the oven thermostat-Do it yourself To Adjust the ThermostatCare and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Oven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverHow to Remove the Storage Drawer to Clean Under the Range Broiler Pan & GridTo remove the storage drawer To replace the storage drawerPorcelain Enamel Cooktop Lift-Up Cooktop on some modelsSurface Units Drip PansTo remove a surface unit To replace a surface unitContinuous-cleaning oven cleans itself while cooking To Clean the Continuous-Cleaning Oven Let the range parts cool before handlingPorcelain Oven Interior on some models Installation of the range Before You BeginPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Before After Wire Conduit Installation Conduit Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Food does not bake Or roast properlyFood does not Broil properly At BroilOven temperature Clock and timerPower outage Too hot or too coldOne Year Hotpoint Range WarrantyWe Will Replace, At No Charge To You TDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES

Related manuals

Manual 40 pages 55.5 Kb