Hotpoint RB632, RB533, RB526, RB536, RB525 owner manual Wire Conduit Installation

Page 33

6 3-Wire Conduit Installation

Remove the 3 screws from the connector block. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Do not remove ground strap connection.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to the connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

Screw
Connector block	Bare wire tips
Connector block terminal
Bare wire
Movable nut
Flexible cable
Bracket	Conduit
	Conduit

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

33

Image 33

Contents Ranges Staple sales slip or cancelled check here Congratulations You Are Now Part of the Hotpoint FamilyWrite the model and serial numbers here Hotpoint & You Service Partnership All ranges can tip and injury could result Important Safety NoticeSafety Precautions Safety Information When Cooking PORK… Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsHow to Set Using the surface unitsSurface Cookware Tips Wok CookingClock and Timer Features Using the clock and timerTo Reset the Timer To Set the TimerTo Cancel the Timer To Set the ClockOven Temperature Knob Using the ovenCustomer Service Troubleshooting Before you begin…Preheating and Pan Placement How to Set the Oven for BroilingAluminum Foil Comments Broiling guideTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfControl Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Oven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverBroiler Pan & Grid How to Remove the Storage Drawer to Clean Under the RangeTo remove the storage drawer To replace the storage drawerLift-Up Cooktop on some models Porcelain Enamel CooktopDrip Pans Surface UnitsTo remove a surface unit To replace a surface unitContinuous-cleaning oven cleans itself while cooking Let the range parts cool before handling To Clean the Continuous-Cleaning OvenPorcelain Oven Interior on some models Before You Begin Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationWire Power Cord Installation Before After Wire Conduit Installation Conduit Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Or roast properly Food does not bakeFood does not Broil properly At BroilClock and timer Oven temperaturePower outage Too hot or too coldHotpoint Range Warranty We Will Replace, At No Charge To YouOne Year Service Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC

Related manuals

Manual 40 pages 55.5 Kb