Frymaster Super Marathon Series, Super Runner Series manual Iii

Page 3

DANGER

The front ledge of the fryer is not a step. Do not stand on the fryer. Serious injury can result

from slips or contact with the hot oil.

DANGER

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any

other cooking appliance.

DANGER

Instructions explaining procedures to be followed MUST be posted in a prominent location in the event the operator detects a gas leak. This information can be obtained from the local gas company or gas supplier.

DANGER

The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying operations each day. Some food particles can spontaneously combust if left soaking in certain shortening material. Additional information can be obtained in the filtration manual included with the system.

WARNING

No structural material on the fryer should be altered or removed to accommodate placement of

the fryer under a hood. Questions? Call the Dean Service Hotline at 1-800-551-8633.

WARNING

Do not bang fry baskets or other utensils on the fryer’s joiner strip. The strip is present to seal the joint between the frypot. Banging fry baskets on the strip to dislodge shortening will distort the strip, adversely affecting its fit. It is designed for a tight fit and should only be removed for cleaning.

IMPORTANT

Safe and satisfactory operation of Dean equipment depends upon its proper installation. Installation MUST conform with local codes, or in the absence of local codes, to European Community (CE) Standards.

iii

Image 3
Contents Hour Service Hotline Super Runner and Super Marathon SeriesMAY Page Iii Table of Contents Parts List Functional Description NON-CE Altitudes of 2000 feet or lessCE only Altitudes of 2000 feet or less Thermostats Pilot Ignition SystemCleaning the Gas Valve Vent Tube Accessing Fryers for ServicingCalibrating the Operating Thermostat Check Burner Manifold Pressure Adjusting the Pilot Flame Replacing Fryer ComponentsReplacing the Operating Thermostat Replacing the Operating Thermostat Replacing the Frypot Replacing the High-Limit ThermostatPilot Failures Troubleshooting and Problem IsolationComplete System Check System Resistance CheckAutomatic Pilot Dropout Check Pilot Fails to Light Improper Burner Functioning Filtration Problems Leaking Current Production Units with Honeywell Gas Valve Non-CE Wiring DiagramsCurrent Production Units with Honeywell Gas Valve CE Current Production Units with Robertshaw Gas Valve After May Optional UFF Filtration Wiring DiagramChannel, Base- Front & Rear Non-Filtration Single Fryers Cabinetry Components, Single FryersSuff Base Components- SM Series With Suff Filtration Side Panel, LeftSide Panel, Right Panel, Outer Door- SM20G Assembly 106-2482SP Door Assembly ComponentsCabinetry Components, Multi-Battery Frying Systems Base Channel, Front & Rear- SM220G, SM50G See .1 ForAdditional Single Fryer Base Channel Components Fluecap, SM20/20/50G AccessoriesDean Millivolt GAS Fryers Parts List Thermostat, Sunne Use 807-1692 for CE 1 SM220 and SM20/20/~ Systems Frypot and Burner System ComponentsFlue Assembly- SM20G SR Series, SM35G, SM40G and SM50G Systems Shield, Burner Heat- SR52G, SM50 Burner, Right- SR38G, SR42G, SM35G, SM40GBurner, Center- SR38G, SR42G, SM35G, SM40G Burner, Left- SR38G, SR42G, SM35G, SM40G106-0954SPFlue Assembly- SM35G, SM40G 25 106-1742SPFlue Assembly- SR52G, SM50GFlue Assembly- SR38G 106-0696SPFlue Assembly- SR42GSM80G Shown 3 SR62, SM60G and SM80G SystemsValve, Trailing Pilot- SM60G, SM80G, SR62G adjustment valve Frypot- M/S- SM80G Prior To 10/99 obsolete useFrypot- S/S- SM60G, SR62G Use 823-3511SP for SM160G Flue Assembly- SM60G, SR62G Flue Assembly- SM80GOil Drain Manifold Componets Drain Valve Components Oil Drain Manifold, Drain Flush and Drain Valve ComponentsPlace Over Flush Oil Drain Line 2 3 Oil Drain Manifold, Drain Flush & Drain Valve ComponentsOil Return Manifold Components Fryers with 1½ Drains Oil Return Manifold Components810-0051 200-1143 809-0877 106-2568SP Not Illustrated Oil Return Manifold Components Fryers with 3 Drains Oil Return and Oil Flush Components Fryers with 1½ Drains Oil Return and Oil Flush ComponentsOil Suction Start Fitting Microswitch Bracket Assembly, Oil ReturnOil Return and Oil Flush Components Fryers with 3 Drains Suction Manifold Assembly Oil Suction Assembly1 SM50 and SM60 Series Fryers Except Ihop Under Fryer Filter UFF Components2 SM50 Series Fryers, Ihop UFF 50 with Filter Leaf 3 SM80 Series Fryers 1 SM50 Series Fryers Single Under Fryer Filter Suff Components2 SM60 and SM80 Series Fryers This page Intentionally Left Blank Service Hotline