2.Inspect the filter pan connection fitting to ensure that both O-rings are in good condition. The O-rings are located on the tube disconnect inside the filter pan as shown on the drawing down and to the right.
3.Place the metal filter screen in the center of the bottom of the pan, then lay a sheet of filter paper on top of the pan, over- lapping on all sides.
4.Position the hold-down ring over the filter paper and lower the ring into the pan, allowing the paper to fold up around the ring as it is lowered to the bottom of the pan.
5.When the hold-down ring is in position, sprinkle one cup of filter powder evenly over the paper.
6.Replace the crumb tray in the filter pan, and then push the filter pan back into the fryer, positioning it under the drain.