Frymaster E4 manual Component Boxes, Contactor Boxes

Page 61

8.4.1Component Boxes cont.

ITEM

PART#

COMPONENT

20

807-3868

Strain Relief

21807-0121 Bushing, Heyco SB-625-500

22816-0217 Paper, Insulating Terminal Block CE

23106-5750 Harness, Full Vat Assembly

24220-0083 Plate, Strain Relief

25807-4036 Switch

807-3575

Plug, Carling Switch Hole (used in place of a switch on some models)

26230-0834 Guard, RE Box Switch

8.4.2Contactor Boxes

Left Assembly 106-6278

Right Assembly 106-6279

Single Assembly 106-6292

 

NOTE 1: Left and right contactor box assemblies are mirror images of one another. With the exception of the box itself, all components of a left-hand assembly, are the same as those in the corresponding right-hand assembly and vice versa.

NOTE 2: See Page 8-17 for Contactor Box Wiring Assembly

continued on the following page…

8-12

Image 61 Contents
Manual Hour Service HotlinePage Canada RE Series Marine Electric Fryers Operator Troubleshooting Iii General Safety InformationService Information Shipping Damage Claim ProcedureController Information Introduction Power Requirements Page Single Fryer with filter Dimensions and WeightsRE Series Marine E4 Electric Fryers Operating Instructions Equipment Setup and Shutdown ProceduresDescription Introduction Controller Operating Instructions Do not cancel the melt-cycle mode if using solid shorteningDisabling or Enabling the MELT-CYCLE Cancel Switch RE Series Marine E4 Electric Fryers Filtration Instructions Inspect O-Rings Screen Filter Paper Open valve by Rotating the handle 90º Page Draining and Disposing of Waste Oil RE Series Marine E4 Electric Fryers Preventive Maintenance Page Fryer Annual/Periodic System InspectionBuilt-In Filtration System RE Series Marine E4 Electric Fryers Operator Troubleshooting Troubleshooting Control and Heating Problems Problem Probable Causes Corrective ActionProblem Start Filtration ProblemsProblem Replacing Component Box Components Replacing a Remote Digital ControllerReplacing a High-Limit Thermostat Replacing a Temperature Probe Replacing a Heating Element Page Replacing Contactor Box Components Replacing a Frypot Reinstall the drain tube assembly Page Disconnect flexlines indicated by the arrows Replacing the Filter Transformer or Filter Relay Diagnostic LED Legend Interface Board Diagnostic ChartProbe Resistance Chart Probe Resistance ChartWiring Diagram, Simplified RE17 Wiring Diagram, System Wiring Diagram, Contactor Box Wiring Wiring Diagram, Wiring Harness Wiring Diagram, Remote Cable Accessories RE Series Marine E4 Electric Fryers Parts ListPage Back Panel, Upper Single FPRE117 Page 106-6452 FPRE217 Double Station Fryer Cabinet Assembly, Fpre Electric Double S/S Drain Tube, Left/Right End Short Valve Assembly, Full Vat Drain FPRE217 Drain Valve Assembly and Component Parts Relays are not replaceable Electronics and Wiring Components 8.4.1 Component BoxesContactor Boxes Component BoxesContactor Boxes Terminal Blocks Heating Element Assembly and Associated Parts Heating Element Assembly and Associated Parts For other controllers, cables and harnesses see manual Component Box and Filter Pump Wiring Harnesses Page Assembly, Filter Pan Single FPRE117 includes pan and lid FPRE217 Filtration Components Suction Tube Oil Return System Components Frypot Assembly and ThermostatOil Return System Components Oil Disposal Plumbing Wiring Connectors, Pin Terminals, Seals, and Power Cords Component Fasteners Service Hotline
Related manuals
Manual 86 pages 38.42 Kb Manual 2 pages 51.67 Kb Manual 36 pages 37.47 Kb