Frymaster E4 manual Replacing Contactor Box Components

8.Reconnect the element connector it was removed from directly behind the frypot, ensuring that the latches lock.

9.Insert the temperature probe leads into the 12-pin wiring harness connector C-6 (see illustration below). For full-vat units or the right half of a dual-vat unit, the red lead goes into position 3 and the white into position 4. For the left half of a dual-vat unit, the red lead goes into position 9 and

the white into position 10. NOTE: Right and left refer to the fryer as viewed from the rear.

Rib marks Position 1

10 4

9 3

Probe Lead Positions

10.Reconnect the 12-pin connector C-6 of the wiring harness disconnected in Step 2.

11.Lower the element down onto the basket rack.

12.Reinstall the tilt housing and back panels, reposition the fryer under the exhaust hood, and reconnect it to the electrical power supply.

7.7Replacing Contactor Box Components

1.If replacing a contactor box component above the built-in filter system, remove the filter pan and lid from the unit. Drain the frypots into a Shortening Disposal Unit (SDU) or other appropriate metal container. If replacing a contactor box component in a non-filter unit or a frypot that’s not over the filter pan, drain the frypot above the box into a Shortening Disposal Unit (SDU) or other appropriate metal container.

DANGER

DO NOT drain more than one full frypot or two split frypots into the SDU at one time.

2.Disconnect the fryer from the electrical power supply.

3.Remove the two screws securing the cover of the contactor box. The contactor boxes above the filter pan are accessed by sliding under the fryer. They are located to the left and right above the guide rails (see photo below). The contactor boxes of non-filter units or frypots not over the filter pan are accessed by opening the fryer door directly under the affected frypot.

Remove two screws to access contactor box components above the filter pan.

7-6