Frymaster 35 Series manual Three screws, on each side of the fluecap, must be removed

Page 15

12.Remove the screws from the sides and back of the fluecap and remove the fluecap.

Three screws, on each side of the fluecap, must be removed.

13.Disconnect the oil return lines or hoses on fryers equipped with filter systems.

14.Lift the frypot, complete with the burner, gas valve, flue, and drain valve, from the fryer cabinet. After lifting the frypot partially out of the cabinet, tilt the front downward to allow the drain valve to clear the cabinet top and front crossbar.

15.Remove the drain valve, hi-limit thermostat, and operating thermostat from the frypot and transfer them to the replacement frypot. Before installing the thermostats and drain valve on the replacement frypot, clean threads and apply Loctite™ PST56765 thread sealant or equivalent to the threads.

16.Reverse the steps of the procedure to install the new frypot.

CAUTION

Before installing the operating thermostat, high-limit thermostat, and drain valve on the replacement frypot, clean their threads and apply Loctite™ PST56765 thread sealant or equivalent to the threads.

1.9Troubleshooting and Problem Isolation

This section is intended to provide technicians with a general knowledge of the broad problem categories associated with this equipment, and the probable causes of each. With this knowledge, the technician should be able to isolate and correct any problem encountered.

Problems you are likely to encounter can be grouped into these broad categories:

1.Pilot failures

2.Improper burner functioning

3.Improper temperature control

4.Filtration problems

5.Leakage problems

1-11

Image 15
Contents Gas Fryers Hour Service HotlineCanada Page Series GAS Fryers Table of Contents Thermostats Functional DescriptionPilot Ignition System Control OptionsInch Adjusting the Pilot Flame Non-CE Gas Valves CE Gas ValvesCalibrating the Thermostat Control On Standard MJ35 Fryers On G-Model Fryers Page Replacing the High-Limit Thermostat in G Series Fryers Page Page Ferrule on thermopile unscrews from bottom of pilot Replacing the Frypot Three screws, on each side of the fluecap, must be removed Unreliable flame Problems Related to the Gas and/or Electrical CurrentPilot Failures No pilot flameProblems Related to the Gas Valve Problems Related to the Electrical CircuitsMillivolt Operator Terminal Panel Improper Burner FunctioningImproper Temperature Control Filtration ProblemsFailure to Control at Setpoint Filter Magic Simplified Wiring Diagram Basket Lift Malfunctions LeakageBell Crank Basket Lift Wiring Diagram Binding/Jamming ProblemsMotor Problems Electrical ProblemsProbe Resistance Chart Probe Resistance ChartComponent AccessoriesBasket Lift Arm, MJ35 Left use 823-06931 for FM35 units Cabinetry System Component WIR0146SP Filter BoxesOne-Piece Filter Pan Assembly Items 7, 8, 10, 11, Frypot FrypotsFM35 MJ35 MJ35VThis page Intentionally Left Blank Components Natural Gas G20/G25 for thermocouple only, use OIL Component Power Shower and OIL Return Handle Components THERMOSTATS, TIMER, and Related Components This page Intentionally Left Blank Service Hotline