Jenn-Air WM27430P, W30400P manual I000, To set oven on Bake or Convect Bake or Convect Roast

Page 9

To set oven on Bake or Convect Bake or Convect Roast

1.Place oven racks on properrack positions.(See page 9.)

2. Touch Bake Pad or Convect Bake Pad or Convect Roast Pad, IndicatorWords BAKE or CONV BAKE or CONV ROAST will flash and three dashes will be shown.

Note: If morethan five secondselapse betweentouchinga pad and touchinga numberpad, Displaywill returnto previousDisplay.

3. Touch the appropriate number pads for desired oven temperature.

Allowable temperature range is 100° to 550°F. After five seconds the oven will beginto preheat. The IndicatorWords ON, PREHEAT,andeither BAKE or CONV BAKE or CONV ROASTwill appear in the Display. The temperature shown will be 100° or the oven temperature whichever is higher.

Example: If at 10 o'clockyou set the oven for 350°for convect baking, after five seconds the Display will show:

I0:00

During the preheat,the Displaywill showa rise in5°incrementsuntil programmed temperature is reached. When the oven is preheated,the oven will chime, the ON and PREHEAT Indicator Words will go off, and programmed oven temperature will remain in the Display.

Note: Oven will preheat for approximately 7 to 11 minutes.

Important: Whenever ON appears in the Display, the oven is heating.

To recall temperature sat during preheat: Touch the appropriate Bake Pad or Conveot Bake Pad orConvect Roast Pad. Temperature will bebrieflydisplayed, then will automatically return to on-going program.

To change temperatureset: Touchappropriate Bake Pador Convect BakePad or Convect Roast Pad and the appropriatenumber pads for the new desired temperature.

Note: If you are loweringthetemperaturebelowthe currentoventemperature,the indicator Words PREHEAT and ON will appear briefly in the Display and the preheatchimewillsound. Then, the Displaywillshowprogrammedtemperature and indicatorword BAKE or CONV BAKE or CONV ROAST only.

4. TouchCancel Off Pad to turn oven off at end of baking. The oven will continue operatinguntilthe Cancel Off Pad is touched.

Image 9
Contents Models OlOww JENN-AIR Dealer from Whom Purchased Jean-Air Customer AssistanceBaking Baking Chart Causes of Cake Failure Convect Baking Baking Baking Chart Causes of Cake Failure Convect Baking Read before operating your oven Function Pads To programNumber Pads To set oven on Bake or Convect Bake or Convect Roast I000Rack Uses Different RacksBasi INSUCTiONS 12TohaPPNate number PadSI To setTime ofDayProgramming To cancel TimerOoo Lga.q o Page IIi!AAiiiiii?i i?iii !!iiiZ!ili2 Page Page Preheating is not necessary 6Oomedu3mo-35 Convect Roasting Frozen to Finish Temp. F linutes Use the Convect Roast Pad for best resultsOOO 8TopIz-3Lo,s 00 Hl 8TopIz-3Lo,s 00 Hl Ili¸iiiiii!,i!!i i!!iiiji !i Page To set oven to start cleaning immediately Steps to Follow for Self-Cleaning ProcessClose the ovendoor TouchClean Pad of ovento be cleaned To maintainthe clean temperature1200 To set oven to start cleaning at a later timeTo cancel self-clean Glass Window or Glass Oven Door Front Oven Door TrimTo replace light bulb Control Panel Area and Display WindowTo set Heat If oven will not go through self-cleaning processIf baked food is burned or too brown on top If foods bake unevenlyMBJENN-AIR