Jenn-Air WM27430P, W30400P manual Mbjenn-Air

Page 37

If baking results differ from previous oven:

•oven thermostat calibration may differ between old and new ovens. Follow recipe and use and care directions before calling for service since the calibration on the previous oven may have drifted to a too high or too low setting. (See p. 34 - Adjusting Oven Temperature.)

If the cooling fan continues to operate after the oven has been turned off:

•this is normal and the fan will automatically shut off when the oven is cooled.

If a fan is heard while using the bake mode:

•this is the cooling fan and is normal. The fan will continue to run after use until the oven cools.

If probe does not work:

•check to be sure probe plug is properly inserted into oven receptacle.

•probe may not be positioned in food properly.

•probe temperature may have been improperly set.

Fault Codes

•Fault codes are shown in the Display as "F" and a number. If a fault code appears in the Display and a continuous beep sounds, touch the Cancel Off Pad. If the fault

code reappears, disconnect power to the oven and call an authorized Jenn-Air Service Contractor.

mBJENN-AIR

 

 

403WESTFOURTHSTREETNORTHoPOBOX39'NEWTON,IA50208

 

Printed

in U.S.A.

 

Cat. No. OU304OOUF

@1997

Jenn Air

Part No. 8111 P343-60

9/97

Page 36 Page 37
Image 37
Page 36 Page 37
Contents Models OlOww JENN-AIR Dealer from Whom Purchased Jean-Air Customer AssistanceBaking Baking Chart Causes of Cake Failure Convect Baking Baking Baking Chart Causes of Cake Failure Convect Baking Read before operating your oven Function Pads To programNumber Pads To set oven on Bake or Convect Bake or Convect Roast I000Rack Uses Different RacksBasi INSUCTiONS 12TohaPPNate number PadSI To setTime ofDayProgramming To cancel TimerOoo Lga.q o Page IIi!AAiiiiii?i i?iii !!iiiZ!ili2 Page Page Preheating is not necessary 6Oomedu3mo-35 Convect Roasting Frozen to Finish Temp. F linutes Use the Convect Roast Pad for best resultsOOO 8TopIz-3Lo,s 00 Hl 8TopIz-3Lo,s 00 Hl Ili¸iiiiii!,i!!i i!!iiiji !i Page To set oven to start cleaning immediately Steps to Follow for Self-Cleaning ProcessClose the ovendoor TouchClean Pad of ovento be cleaned To maintainthe clean temperature1200 To set oven to start cleaning at a later timeTo cancel self-clean Glass Window or Glass Oven Door Front Oven Door TrimTo replace light bulb Control Panel Area and Display WindowTo set Heat If oven will not go through self-cleaning processIf baked food is burned or too brown on top If foods bake unevenlyMBJENN-AIR
Top Page Image Contents