Extron electronic XPA2001-70V, XPA1002 manual FCC Class B Notice, Specifications Availability

Page 3

FCC Class B Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.

Conventions Used in this Guide

WARNING: A warning indicates a situation that has the potential to result in death or severe injury.

ATTENTION: Attention indicates a situation that may damage or destroy the product or associated equipment.

NOTE: A note draws attention to important information.

Specifications Availability

Product specifications are available on the Extron website, www.extron.com.

Copyright

© 2012 Extron Electronics. All rights reserved.

Trademarks

All trademarks mentioned in this manual are the properties of their respective owners.

Image 3
Contents User Guide Safety Instructions English FCC Class B Notice Specifications AvailabilityPage Contents Page Terms Used in this Manual FeaturesContinuous power output for larger rooms About this ManualXtra Series Introduction XPA 1002 Application Example Application ExamplesMounting the XPA 1002 and XPA Tabletop UseUL Guidelines for Rack Mounting Rack Mounting of the Amplifier Rack MountingAllow Sufficient Spacing for Adequate Ventilation Flexible Conduit Adapter Kit InstallationUL Requirements Removing the IEC Connector Power indicator LED This LED lights Front Panel Features and OperationLIMITER/PROTECT Attenuation Inputs Remote Rear Panel Features and OperationInputsinputs See Remote Volume Control on XPA XPA Do not tin the wires Remote Volume Control Controlling Multiple Amplifiers with One Volume Controller Bridging the Output of the XPA Bridged Mono OutputTroubleshooting Amplifier Fails to Exit Standby Mode PromptlyAmplifier Enters Standby Mode Too Early Limiter/Protect LED Warning Indicators Over Temp Indicator LEDLED State Problem Description Problem Solution Accessories Part number Part Numbers and AccessoriesOptional Accessories Included parts Replacement Part numberEurope USA, Canada, South America Japan Central AmericaEurope and Africa China Asia Middle East