Extron electronic XPA2001-70V, XPA1002, XPA2001-100V manual Xpa

Page 21

To wire the stereo audio output connector:

Step 1: Strip and insert the speaker wires into the connector and tighten the captive screws. Be sure to observe the correct polarity.

Do not tin the wires!

Step 2: Insert the wired connector into the amplifier output and secure the locking screws on either side.

 

 

4Ω

OUTPUTS

8Ω

/

2

 

1

 

 

 

 

 

 

 

G

 

 

 

2

ÇMono audio output connector — Marked “+” and “-”, wire the included 2-pole,

5 mm screw lock captive screw connector for mono audio. See the following steps on the next page. Output is designed to power 70 V (XPA 2001-70V) or

100 V (XPA 2001-100V) line distribution systems and is rated at 200 watts.

NOTES: • You must use Class 2 wiring for this output to comply with UL requirements.

•The mono audio output connector may be labeled one of two ways (see the images below). The wiring and function are the same,

whichever way your product is labeled.

70 V OUTPUT

OUTPUT

 

70V

or

CLASS 2 WIRING

XPA 2001-70V

100 V OUTPUT

OUTPUT

 

100V

or

CLASS 2 WIRING

XPA 2001-100V

ATTENTION: Failure to follow these instructions may result in damage to the unit.

Do not tie channel outputs 1 and 2 to each other or to ground. Doing so will short out the outputs and/or damage the amplifier.

XTRA Series • Operation

15

Page 20 Page 22
Image 21
Page 20 Page 22
Contents User Guide Safety Instructions English FCC Class B Notice Specifications AvailabilityPage Contents Page Continuous power output for larger rooms FeaturesAbout this Manual Terms Used in this ManualXtra Series Introduction XPA 1002 Application Example Application ExamplesMounting the XPA 1002 and XPA Tabletop UseUL Guidelines for Rack Mounting Rack Mounting of the Amplifier Rack MountingAllow Sufficient Spacing for Adequate Ventilation Flexible Conduit Adapter Kit InstallationUL Requirements Removing the IEC Connector Power indicator LED This LED lights Front Panel Features and OperationLIMITER/PROTECT Attenuation Inputs Remote Rear Panel Features and OperationInputsinputs See Remote Volume Control on XPA XPA Do not tin the wires Remote Volume Control Controlling Multiple Amplifiers with One Volume Controller Bridging the Output of the XPA Bridged Mono OutputTroubleshooting Amplifier Fails to Exit Standby Mode PromptlyAmplifier Enters Standby Mode Too Early Limiter/Protect LED Warning Indicators Over Temp Indicator LEDLED State Problem Description Problem Solution Optional Accessories Part Numbers and AccessoriesIncluded parts Replacement Part number Accessories Part numberEurope and Africa China USA, Canada, South America Japan Central AmericaAsia Middle East Europe
Top Page Image Contents