Extron electronic XPA1002, XPA2001-70V, XPA2001-100V manual Do not tin the wires

Page 22

To wire the mono audio output connector:

Step 1: Strip and insert the speaker wires into the connector and tighten the captive screws. Be sure to observe the correct polarity.

Do not tin the wires!

Step 2: Insert the wired connector into the amplifier output and secure the locking screws on either side.

			T
	V	OUTPU
70	V
70
			G
		2	WIRIN
		2
CLASS

HHigh pass filter toggle switch — Use a small screwdriver to toggle this recessed two-position toggle switch that alternates between Off (no filtering) and 80 Hz (default). Setting the switch to 80 Hz prevents the saturation of 70 V/100 V speaker input transformers by low frequency signals. Saturation can result in severe distortion of the speaker output signal.

NOTES: • The high-pass filter may be safely turned off if it is applied to the source input signal upstream of the amplifier. Otherwise, it should be left on.

•The high-pass filter toggle switch may be labeled one of two ways. The wiring and function are the same, whichever way your product is

labeled.

XTRA Series • Operation

16

Image 22

Contents User Guide Safety Instructions English Specifications Availability FCC Class B NoticePage Contents Page About this Manual FeaturesContinuous power output for larger rooms Terms Used in this ManualXtra Series Introduction Application Examples XPA 1002 Application ExampleTabletop Use Mounting the XPA 1002 and XPAUL Guidelines for Rack Mounting Rack Mounting Rack Mounting of the AmplifierFlexible Conduit Adapter Kit Installation Allow Sufficient Spacing for Adequate VentilationUL Requirements Removing the IEC Connector Front Panel Features and Operation Power indicator LED This LED lightsLIMITER/PROTECT Rear Panel Features and Operation Attenuation Inputs RemoteInputsinputs See Remote Volume Control on XPA XPA Do not tin the wires Remote Volume Control Controlling Multiple Amplifiers with One Volume Controller Bridged Mono Output Bridging the Output of the XPAAmplifier Fails to Exit Standby Mode Promptly TroubleshootingAmplifier Enters Standby Mode Too Early Over Temp Indicator LED Limiter/Protect LED Warning IndicatorsLED State Problem Description Problem Solution Included parts Replacement Part number Part Numbers and AccessoriesOptional Accessories Accessories Part numberAsia Middle East USA, Canada, South America Japan Central AmericaEurope and Africa China Europe