Henny Penny 590, 592 manual Pressure PAD, Pressure pads are plastic strips that the lid cam presses

Page 10

	Model 590/592
2-13. PRESSURE PAD	The pressure pads are plastic strips that the lid cam presses
	against to seal the lid.

1.Raise the lid.

2.Remove the 4 screws securing the lid cover and remove cover.

3.Push the lid cam back, off of the pressure pads.

4.Using an Allen wrench, remove the large bolt securing the pad.

5.Using a Phillips head screw driver, remove the small screw securing the pad and remove the broken pad.

If the pressure pad is worn, but not broken, it can be reversed 180 degrees, and the other end of the pad used.

6.Install new pad in reverse order.

2-10

1103

Image 10

Contents Introduction MaintenanceMaintenance Hints PreventiveCheckout High Temperature Limit Control Fuse HoldersReplacement Temperature Probe Replacement Excess force will damage temperature probeEvery 90 days Yearly InspectionReversing the LID UprightGasket Model 590/592 Pressure pads are plastic strips that the lid cam presses Pressure PADAgainst to seal the lid LID Adjustment Solenoid Valve If the core-disc assembly is sticking due to buildup Deadweight Valve Solenoid ValveDeadweight Valve Removal & Cleaning Safety Relief ValvePressure Gauge Cleaning StepsValve Calibration StepsContactors 30 31 34 35If either contactor proves defective, replace as follows Wires Power AmperageHeating Elements Heating Elements 4 mm Gap Extension Drain valve opens when the drain valve handle is pulledDrain Valve Out and drains the shortening out of the potNylatron Strips Replacement Nylatron Strips Replacement