Henny Penny 590, 592 manual Nylatron Strips Replacement

Page 24

Model 590/592

2-23. NYLATRON STRIPS REPLACEMENT

1.Raise the lid and remove the retention ring from one end of the lid pin.

2.Slide the lid pin from unit.

3.Lift the lid from unit.

The lid weighs 80 lbs (36 kg). Take care when lifting lid to prevent personal injury.

4.Using a 3/8” socket, remove the nuts securing the rear shroud and remove shroud.

5.Using a Phillip’s-head screwdriver, remove the screws securing the top cap and remove top cap.

6.Remove the bolts securing the nylatron strips to the weight assembly and remove strips from weight assembly.

7.Using a Phillip’s-head screwdriver, remove the screws securing the front shroud.

8. Unfasten the exhaust hose from the hose clamp.

2-24

1103

Image 24

Contents Maintenance Maintenance HintsIntroduction PreventiveCheckout High Temperature Limit Control Fuse HoldersReplacement Temperature Probe Replacement Excess force will damage temperature probeEvery 90 days Yearly InspectionUpright Reversing the LIDGasket Model 590/592 Pressure PAD Pressure pads are plastic strips that the lid cam pressesAgainst to seal the lid LID Adjustment Solenoid Valve If the core-disc assembly is sticking due to buildup Deadweight Valve Solenoid ValveDeadweight Valve Removal & Cleaning Safety Relief ValveCleaning Steps ValvePressure Gauge Calibration StepsContactors 30 31 34 35If either contactor proves defective, replace as follows Wires Power AmperageHeating Elements Heating Elements 4 mm Gap Drain valve opens when the drain valve handle is pulled Drain ValveExtension Out and drains the shortening out of the potNylatron Strips Replacement Nylatron Strips Replacement