Henny Penny 592, 590 manual LID Adjustment

Page 11

	Model 590/592
2-14. LID ADJUSTMENT	If steam leaks out from around the lid gasket, the pressure pads
	could be worn or broken. If the pressure pad is worn, but not
	broken, it can be reversed 180 degrees, and the other end of the
	pad used. See Pressure Pad Section.
	If steam leaks, check for:

• Pressure pad wear

• Cracked or worn gasket

• Gasket installed improperly

• Fryer operating above 12 psi (827 mbar)

Fryer should be operating at 12 psi, or serious burns could result.

1103

2-11

Image 11

Contents Preventive MaintenanceMaintenance Hints IntroductionCheckout High Temperature Fuse Holders Limit ControlReplacement Excess force will damage temperature probe Temperature Probe ReplacementYearly Inspection Every 90 daysGasket UprightReversing the LID Model 590/592 Against to seal the lid Pressure PADPressure pads are plastic strips that the lid cam presses LID Adjustment Solenoid Valve If the core-disc assembly is sticking due to buildup Solenoid Valve Deadweight ValveRemoval & Cleaning Safety Relief Valve Deadweight ValveCalibration Steps Cleaning StepsValve Pressure Gauge30 31 34 35 ContactorsIf either contactor proves defective, replace as follows Amperage Wires PowerHeating Elements Heating Elements 4 mm Gap Out and drains the shortening out of the pot Drain valve opens when the drain valve handle is pulledDrain Valve ExtensionNylatron Strips Replacement Nylatron Strips Replacement