Hoshizaki JWE-620UA-6B service manual Removal and Replacement of Handle

Page 59

F. Removal and Replacement of Handle

1)Unscrew the door link shaft with the door closed. While holding the handle by hand to prevent it from springing back, remove the link arms and related parts from the shaft.

WARNING

Be sure to hold the handle, or it may spring back and cause injury.

2)Remove the screws securing the handle to the arms, and pull off the handle. Note: A plastic hammer or other tools may be required to pull off the handle.

3)To replace, reverse the above procedure.

4)Check the door for proper movement.

Arm

Handle Mounting Screw

Handle Mounting Screw

Door

Link Shaft

Bolt

Link Arm

Link Shaft Mounting Bolt

Handle

Hose (A) Collar (A) - Handle

Collar (B) - Handle

Cap - Shaft (B)

54

Image 59

Contents Model JWE-620UA-6B Hoshizaki AMERICA, INC Contents Page Important Safety Information Display Speciﬁcations Speciﬁcation SheetNameplate Rating Dimensions/Connections Dishwasher II. General Information A. ConstructionInternal Booster Tank Auxiliary Code U-1, U-2, U-3, V-0, A-0 Control BoxAuxiliary Code A-1 and Later Auto Fill lamp ﬂashing and RINSE, STANDARD, or Long lamp on Sequence of OperationAuto Fill Cycle Wash Cycle Rinse Cycle STANDBY/CLEANING Button StartDrain Rinse lamp ﬂashingSequence of Operation Flow Chart Auxiliary Code A-1 and Later Control Board Location Control Board and Operation BoardCN5 Control Board LayoutCN9 Control Board DiagramX10 Auto Fill Lamp Error CodesMode Lamps Ready LampStandby Lamp Mode ButtonSTANDBY/CLEANING Button Service Menu AccessDefault Service Menu Chart Auxiliary Code U-1, U-2, U-3, V-0, A-0Service Menu Chart Auxiliary Code A-1 and Later Temperature Display Special Modes Error CodesInternal Booster Tank Energy Saving Mode BuzzerAlert Function Auxiliary Code A-1 and Later Continuous Wash ModeConsecutive Rinse Mode OFF Switch Open/Closed Display Mode III. Service DiagnosisDiagnostic Procedure Page Error Code Table Error CodesError Code Log Auto Fill Error A1 Error Code DetailsInternal Booster Tank Auto Fill Error A2 Wash Tank Water Level Error A3 Defective Replace Control Board Repair or replace Replace Wash Tank Thermistor Error H1, H2 Internal Booster Tank Thermistor Error H3, H4 Eeprom Error H6 ROM/RAM Error H5Phase Reversal Error H7 Unit Will Not Start Service Flow ChartsPage Dishes Not Clean Page Inadequate Rinse Dishwasher Will Not Start When Door Closed Wash Tank Water Boils No or Inadequate Detergent/Rinse Aid SupplyWash Tank Water Not Draining Float Switch Cleaning Float Switch Check and CleaningFloat Switch Check Thermistor Check Removal of Panels IV. Removal and Replacement of ComponentsAccessing the Control Box Page Removal and Replacement of Internal Booster Tank Removal and Replacement of Wash Pump Motor Removal and Replacement of Rinse Pump Motor Removal and Replacement of Handle Removal and Replacement of Door Removal and Replacement of Spring Removal and Replacement of Spring UnitAdjustment of Door Opening/Closing Force Removal and Replacement of Flush Pipe Packing Installation Instructions Removal and Replacement of Thermistor Operation Board Removal and Replacement of Control Board or Operation BoardControl Board Page Cleaning and Maintenance Instructions Daily Maintenance Pump Filter Water Level Sensor Location Front Self-Cleaning Monthly Inspection Weekly MaintenanceDescaling As Required Shutdown Long Storage, Relocation, Disposal, Transfer VI. Operating Instructions VII. Technical Information Water Circuit Auxiliary Code U-1, U-2, U-3, V-0, A-0 Wiring DiagramAuxiliary Code A-1 and Later