Ice-O-Matic GEM0956A/W, GEM1256A/W R&R-Auger, To Remove the Auger, GEM0650/0956/1256 A/W, Page

Page 33
R&R-Auger

GEM0650/0956/1256 A/W

R&R-Auger

To Remove the Auger:

1. Disconnect electrical power.

2. Turn off the water to the machine.

3. Unclip the evaporator drain hose, pull it down and drain the evaporator into the bin or container.

4. Remove the top panel.

5. Swing bail clip down and remove the ice chute cover.

6. Unscrew ice sweep.

7. Remove ice chute body.

8. The auger and breaker/bearing may now be removed as an assembly.

a. Unscrew four (4) Allen head cap screws holding breaker to evaporator. b. Lift up on breaker and remove auger from evaporator.

Note: If the auger is stuck, the breaker must be removed from the auger.

9.The breaker may be removed from the auger and evaporator without disturbing the auger.

a.Unscrew breaker cover from the breaker. (Note: Left hand Threads)

b.Unscrew auger stud from top of auger.

c.Unscrew four (4) Allen head cap screws holding breaker to evaporator.

d.Lift up and remove breaker from evaporator.

e.If the auger is stuck, use a slide hammer type of puller to pull on the auger at the threaded hole. The size of that hole is 5/8”-18.

10.Inspect the auger, the critical areas of the auger are:

a.The auger body. It should be clean and shining. Sometimes an auger will appear clean when wet, but after it is dry it will be seen to be stained. Scrub the auger with ice machine cleaner and hot water.

b.The water seal area. Because the auger has been removed, the water seal will have to be replaced. Remove the water seal top half from the auger, and inspect the auger for minerals, clean as required.

Breaker and

Auger Assembly

WARNING!

 

 

 

 

The auger has

 

 

 

 

sharp edges,

 

 

 

 

 

Slide Hammer Puller

handle with care.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Thread into

 

 

 

 

the Auger

 

 

 

 

Here

 

 

 

 

 

 

Page 27

Image 33
Contents SERVICE AND INSTALLATION MANUAL GEM0650A/W,GEM0956A/W and GEM1256A/WGEM0655 Air Page Forward GEM0650/0956/1256 A/WKeep this manual for future reference PageTable of Contents Table Of ContentsInspect Promptly Freight Claim ProcedureVisible Loss or Damage Concealed Loss or DamageICE-O-Matic WarrantyLimitation of Warranty Filing a ClaimInstallation Guidelines For the InstallerElectrical Specifications AdjustmentsGEM0650/0655/0956A/W For The InstallerGEM1256A/W Bin Application Ice Machine SpecificationsStorage Bin LocationIce machine Water LimitationsGEM 0650/0956/1256 A/W Water Inlet For the PlumberWATER COOLED MODELS AIR COOLED MODELSElectrical Connections For the ElectricianWater Cooled Models Air Cooled ModelsFinal Check List GEM0650/0956/1256A/WStart Up Pre-StartInspectionStart Up Air Cooled Model Shown Component DescriptionGEM0650/0956/1256 A/W Component Description Evaporator Motor Water Seal Ice Sweep Bearing Breaker/Divider AugerElectrical Sequence To ResetElectrical Sequence Shut DownWater System Operation WaterLow Pressure Cut Out- Automatic Reset High Pressure Cut Out- Automatic ResetOperation: Performance Typical Low Side PressureICE MAKING SYSTEM: In place cleaning Sanitizing and Cleaningscheduled at a minimum of twice a year KEEP OUT OF THE REACH OF CHILDRENBearing Maintenance Bearing MaintenanceNote Left Hand Threads Sensor Maintenance Bin Control SensorWater Sensor Clean the air cooled condenser Maintenance Air CooledGEM0956 GEM06501. Disconnect electrical power to the ice machine Auger MaintenanceAuger 2. Turn off the water supply to the ice machineSymptom Service DiagnosisPossible Cause Probable CorrectionSymptom 4.High pressure cut out check Control System DiagnosticsR&R- Water Reservoir, Bin Control Water ReservoirBin Controls Ice Level Sensors R&R-Bearingand Breaker To Remove the Breaker Bearing AssemblyTo Remove the Auger R&R-AugerTo Remove the Water Seal R&R-WaterSealRemoval of the Water Seal To Replace the Water SealR&R-Evaporator To Replace the EvaporatorTo Reassemble the Evaporator and Auger R&R-GearMotor To Remove and Repair the Gear Motor AssemblyTo Check the Gear Motor To Inspect the Gear MotorR&R-FanBlade and Motor Instructions for Liquid Charging R404A Refrigeration ServiceWiring Diagram GEM0650 A/W GEM0650 Wiring DiagramWiring Diagram GEM0956 A/W GEM0956 Wiring DiagramWiring Diagram GEM1256 A/W GEM1256 Wiring DiagramWiring Diagram GEM0655 Air GEM0655 Wiring DiagramWhat to Do Before Calling for Service Service History