GE Monogram Level the Range, Replace Oven Doors, Front LEG Adjustment, Rear LEG Adjustment

Page 15

Installation

STEP 7 LEVEL THE RANGE

WARNING

The range must be level and be supported

by the legs—not the wheels. The range could move if the wheels make contact with the floor. Be sure all legs make contact with the floor in any installation.

•All legs must be leveled after the product is installed.

•Check to be sure the adjoining cabinets/ countertops are level, front to back and left to right across the opening of the range.

•Measure the distance from the floor to the top

of the countertop in the left and right rear corners.

•Adjust the height of the range to countertop height or higher.

IMPORTANT: This range should always be installed at countertop height or higher. DO NOT INSTALL THE RANGE LOWER THAN ADJACENT COUNTERTOP HEIGHT. The range must be supported by all 4 legs, regardless of countertop height.

FRONT LEG ADJUSTMENT

•Slide front cylinders up to adjust front leveling legs. Be careful not to damage cylinder.

•A leveling leg wrench is supplied. Reach under the front of the range near the right side. Locate and remove a thumb screw, then slide wrench out of the slot.

Thumb Screw

Slide leg cylinder up.

•Use the supplied wrench to turn the front leveling legs. Turn clockwise to raise the range above the wheels. Turn counterclockwise to lower the legs.

•Be sure to return the wrench to its storage slot for future use.

15

STEP 7 LEVEL THE RANGE (cont.)

REAR LEG ADJUSTMENT

•Remove two screws from rear vent trim. Slide vent trim forward, then lift up to remove.

•Find the two rear leg extension rods. Use a 1/4" driver or wrench to adjust the left or right rear legs.

Rear Vent Trim

Rear Leg

Extension Rod

•Replace the rear vent trim using the original screws.

STEP 8 REPLACE OVEN DOOR(S)

Skip this step if oven doors are in place.

IMPORTANT: Do not lift the door by the handle.

To replace the oven doors:

•Firmly grasp the door at the top sides.

This is critical.

•Approach the range with the door angled in a vertical position.

•Guide the hinges into the slots. •Push the door in firmly while opening.

•Once in position, open the door completely. Push the hinge locks back in and toward the front frame.

CAUTION: Take care when replacing the oven doors. If the hinge latch is not securely locked, the hinge may snap back and separate.

If the hinge separates, you must apply pressure (possibly with your foot) to press it back together and then engage the hinge latch.

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Instrucciones de instalación Instructions d’installationRead these instructions completely and carefully Installation InstructionsVent hood Combinations Completion Time 1 to 3 hoursModels Available ContentsBacksplash Accessories Design InformationRange Models Design InformationTo 4-3/4 Toekick/leg Height Minimum To Adjacent Wall Above the range and below Wide Range Models48, 36 and 30 Range Models Product Dimensions and ClearancesMaterials Provided Installation InformationWB28K10553 High Altitude KIT WB28K10554 DE-RATE KITGas Supply Installation PreparationPower Supply Locations See 3-wire power cord installation on the nextDo not remove the ground strap connection Wire Power Cord InstallationInstallation Remove PackagingTo remove the oven doors Tilt the range to lower the hand-truck wheels off the skid Move the Range IndoorsTilt the range forward on the skid Lift the toekick out of the foam baseAnti-Tip Bracket Anti-Tip Brace Aham Anti-Tip Safety BrochureAnti-Tip Parts Provided Hex Screws Anti-Tip Brace Alternate Brace PositionAssure that gas supply is turned off at the shut-off valve Connect Range to GASRoll Range Into Position Connect ElectricalLevel the Range Front LEG AdjustmentRear LEG Adjustment Level the RangeRecheck Steps Finalize InstallationInstallation Checklist Check BurnersACCESSORIES-TOEKICK provided Top Toekick BottomToekick Push This Kit Includes Optional ACCESSORIES-12 High BacksplashInstall 12 Backsplash Tools and Materials RequiredACCESSORIES-30 to 36 Adjustable Backsplash not included Install the Wall Support PanelsMaximum shelf load-bearing weight is 40 lbs Alternate Method When side access is blocked Install Cover PanelsInstall Cover Panels See alternate method if side access is blockedConvert the Regulator Tools YOU Needed for ConversionChange Burner Orifices ZDP364, ZDP366, ZDP484, ZDP486 Installation Instructions for Gas ConversionChange Burner Orifices Change Grill Orifice if presentChange Griddle Orifice if present Adjust Burner FlamesDispositions de hotte d’extraction Consignes d’installationRemarque à l’attention de l’installateur Temps d’installation 1 à 3 heuresDosseret CaractéristiquesTable DES Matières Modèles DisponiblesModèles de cuisinière 121 cm Dimensions DU Produit ET Espaces DE SéparationModèles de cuisinière 91 cm 36’’ Caractéristiques Dimensions DE L’APPAREIL ET EspacesModèles de cuisinière 76 cm 30’’ Dimensions DE L’APPAREIL ET EspacesModèles de cuisinière 76 cm 30’’, 91 cm 36’’ et 121 cm 10-1/2 24,13 cm 13/16 2 cm Dosseret 30-36 En option28-1/4 70,96 cm Jusquà lavant de la porte Outils Nécessaires KIT Haute Altitude WB28K10553KIT DE Réduction DES Caractéristiques Nominales WB28K10554 Matériel FourniAlimentation électrique Préparation de l’installationEmplacement DES Alimentations Alimentation de gazInstallation DU Cordon ’ALIMENTATION 4 Fils Installation DU Cordon ’ALIMENTATION 3 FilsNE retirez PAS le branchement du conducteur de terre Rainure Verrou de charnière Étape 1 Sortez L’APPAREIL DE SON EmballagePour retirer lales portes AttachesÉtape 2 Déplacez LA Cuisinière À L’INTÉRIEUR Soulevez la plinthe du socle en moussePlinthe Pièces du support anti-basculement fournies Vis à boisVis à tête hexagonale Nécessaires, 1 de Rechange Équerre ’utilisez pas de flamme pour vérifier les fuites de gaz Assurez-vous que le gaz est coupéÉtape 8 Replacez Lales Portes DU Four Étape 7 Ajustez LE Niveau DE LA CuisinièreÉtape 7 Ajustez LE Niveau DE LA Cuisinière suiteTerminez L’INSTALLATION Étape 9 Vérifiez LES BrûleursCouvercle d’aération de la plaque chaufffante ACCESSOIRES-PLINTHE fournie Bas dePlinthe Poussez Ce Kit comprend Accessoires EN OPTION-DOSSERET DE 30 CM 12 DE HauteurInstallez LE Dosseret 30 CM Avertissement Ce dosseretOutils ET Matériel Nécessaires ACCESSOIRES-DOSSERET Ajustable 30-36 non fourniInstallez LES Panneaux DE Support Mural Avertissement Les panneauxMéthode Alternative en cas d’obstruction de l’accès latéral Installez LES Panneaux DE RecouvrementInstallez LES Panneaux DE Recouvrement suiteSupport D’ORIFICE Convertir LE RégulateurPrincipaux Consignes d’installation pour la conversion de gazOrifices DE Miijotage ZDP304 MiijotageAjustez LES Flammes DU Brûleur Tiempo de finalización de 1 a 3 horas Antes DE ComenzarModelos a gas natural de Modelos a gas LP deModelo a gas LP de 30 ZDP304L Dimensiones Y Espacios DEL Producto Gas Modelos de cocina deModelos de cocina de 30 de ancho Dimensiones Y Espacios DEL Producto Información de diseñoModelos de cocinas de 48, 36 y Herramientas Requeridas Información de instalaciónKIT DE Reducción WB28K10554 Materiales ProvistosSuministro eléctrico Preparación para la instalaciónUbicaciones DEL Suministro DE Energía Suministro de gasInstalación DE Cable DE Energía DE 4 Hilos Instalación DE Cable DE Energía DE 3 HilosNo Quite la cinta de conexión a tierra Quite LAS Puertas DEL Horno Sólo InstalaciónPaso 1 Quite EL Empaque Para quitar las puertas del hornoPlaca de protección Paso 2 Traslade LA Cocina AL InteriorQuite la placa de protección de la base de espuma Incline la cocina hacia un lado y quite el bloque de espumaTornillos para madera Piezas anti-volcaduras provistasNo utilice una llama para verificar pérdidas de gas Paso 5 Conecte LA ElectricidadPaso 7 Nivele LA Cocina Ajuste DE LAS Patas DelanterasTornillo de apriete manual Tapa de ventilación de la plancha Paso 9 Controle LOS QuemadoresFinalice LA Instalación Vuelva a chequear los pasosAccesorios Placa DE Protección Provisto Parte inferior de laPlaca de protección Presione Este kit incluye Accesorios Opcionales Salpicadero Alto DEInstale EL Salpicadero DE Herramientas Y Materiales RequeridosAdvertencia Los paneles Accesorios -SALPICADERO Ajustable DE 30 a 36 no incluidoLea estas instrucciones por completo y con detenimiento Instale El tornillo Instale tornillos en las esquinas Instale LOS Paneles DE CubiertaInstale LOS Paneles DE Cubierta InstaleLos orificios y convertir el regulador de presión Convierta EL ReguladorHerramientas Necesarias Para LA Conversión Cambie LOS Orificios DE LOS QuemadoresCambie EL Orificio DE LA Parrilla si corresponde Instrucciones de instalación para conversión de gasCambie LOS Orificios DE LOS QuemadoresAjuste la configuración de la hilera superior Cambie EL Orificio DE LAPlancha si corresponde GE Consumer & Industrial

Range specifications

The GE Monogram Range stands as a pinnacle of luxury and functionality in the realm of kitchen appliances. Designed for culinary enthusiasts and home chefs alike, this range embodies superior performance, cutting-edge technology, and exquisite craftsmanship. One of the main features of the GE Monogram Range is its impressive cooking power, with true European convection that ensures even baking and precise temperature control, making it ideal for a wide array of cooking techniques.

Equipped with powerful burners, including a 20,000 BTU tri-ring burner, the GE Monogram Range offers versatility for both high-heat searing and low-simmer sauces. The ranges typically feature a combination of gas burners, electric ovens, and induction cooktops, catering to diverse cooking preferences. The gas models provide instant heat adjustments, while the induction options offer faster cooking times and enhanced energy efficiency.

The technology embedded in the GE Monogram Range enhances the cooking experience significantly. With smart technology integration, users can connect the appliance to their smartphones for remote control and monitoring via the GE Appliances app. This feature allows cooks to preheat the oven, adjust cooking temperatures, and even set timers from anywhere in their home.

Another hallmark of the GE Monogram Range is its customizable design. Available in various finishes, including stainless steel and bold colors, these ranges can seamlessly blend into any kitchen aesthetics. The option to select additional features, such as griddle plates and customizable backguards, provides homeowners with the ability to tailor their range to their specific culinary desires.

The self-cleaning feature of the GE Monogram Range is yet another advantage, utilizing high-temperature cleaning that incinerates debris and leaves behind only a fine ash, which can be easily wiped away. This makes maintenance straightforward and keeps the range looking pristine.

Safety is also paramount, with features like a gas safety shut-off valve, which provides peace of mind for families. Additionally, the ranges are equipped with advanced oven controls that include a delay bake option, allowing users to schedule baking to start automatically.

In summary, the GE Monogram Range is a true embodiment of luxury, efficiency, and modern technology, catering to the needs of discerning home chefs. With its standout features and adaptable design, it not only elevates kitchen aesthetics but also transforms cooking into an effortless and enjoyable experience.
Top Page Image Contents