GE Monogram Range Check Burners, Finalize Installation, Installation Checklist, Recheck Steps

Page 16

Installation

STEP 9 CHECK BURNERS

Check to be sure that burner heads and caps are securely seated.

Burner Cap Properly Seated

Burner Cap Not Properly Seated

•Check for proper ignition:

–Push in one control knob and turn to LITE position.

–The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit.

–First test may require some time, while air is flushed out of the gas line.

–Turn knob to OFF.

–Repeat the procedure for each burner.

IMPORTANT: If the igniter electrodes continue to spark after the burners are lit, check that each burner component is assembled properly. Refer to the Owner’s Manual.

•Burner flames should be blue and stable with no yellow tips, excessive noise or lifting of the flame from the burner. If any of these conditions exist, check that the burner ports are not blocked.

If one of these conditions continues, call for service.

FINALIZE INSTALLATION

Place the burner grates over the burners.

The grates should be seated and should not rock.

The griddle is secured with screws. It is designed to be stationary and should not be removed.

The griddle has two leveling screws beneath the rear flue cover that can be used to adjust to the desired slope.

Griddle Flue Cover

Leveling Screws

Clamping Screws

The two inner screws are clamping screws for securing the griddle in place. Loosen these two screws before leveling. Do not remove these two screws.

The two outer screws are leveling screws. Do not remove these two screws. They can be turned to level the griddle or to provide a forward slope to help grease and oils drain away from the food being cooked.

After leveling the griddle, hand-tighten the clamping screws; do not over-tighten.

INSTALLATION CHECKLIST

❑Make sure all controls are left in the OFF position.

❑Make sure the flow of combustion and ventilation air to the range is unobstructed.

❑Recheck Steps:

Double check to make sure everything in this manual has been completed. Rechecking steps will ensure safe use of the range.

NOTE: The rating plate is located on the bottom

of the control panel and is visible when the oven door is opened. The model and serial number is behind the left knob and is visible when the knob is pulled off.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Instructions d’installation Instrucciones de instalaciónInstallation Instructions Vent hood CombinationsCompletion Time 1 to 3 hours Read these instructions completely and carefullyContents Backsplash AccessoriesDesign Information Models AvailableDesign Information Range ModelsTo 4-3/4 Toekick/leg Height Wide Range Models Minimum To Adjacent Wall Above the range and belowProduct Dimensions and Clearances 48, 36 and 30 Range ModelsInstallation Information WB28K10553 High Altitude KITWB28K10554 DE-RATE KIT Materials ProvidedInstallation Preparation Power Supply LocationsSee 3-wire power cord installation on the next Gas SupplyWire Power Cord Installation Do not remove the ground strap connectionRemove Packaging InstallationTo remove the oven doors Move the Range Indoors Tilt the range forward on the skidLift the toekick out of the foam base Tilt the range to lower the hand-truck wheels off the skidAnti-Tip Brace Aham Anti-Tip Safety Brochure Anti-Tip Parts ProvidedHex Screws Anti-Tip Brace Alternate Brace Position Anti-Tip BracketConnect Range to GAS Roll Range Into PositionConnect Electrical Assure that gas supply is turned off at the shut-off valveFront LEG Adjustment Rear LEG AdjustmentLevel the Range Level the RangeFinalize Installation Installation ChecklistCheck Burners Recheck StepsTop Toekick Bottom ACCESSORIES-TOEKICK providedToekick Push Optional ACCESSORIES-12 High Backsplash Install 12 BacksplashTools and Materials Required This Kit IncludesInstall the Wall Support Panels ACCESSORIES-30 to 36 Adjustable Backsplash not includedMaximum shelf load-bearing weight is 40 lbs Install Cover Panels Install Cover PanelsSee alternate method if side access is blocked Alternate Method When side access is blockedTools YOU Needed for Conversion Convert the RegulatorChange Burner Orifices Installation Instructions for Gas Conversion Change Burner OrificesChange Grill Orifice if present ZDP364, ZDP366, ZDP484, ZDP486Adjust Burner Flames Change Griddle Orifice if presentConsignes d’installation Remarque à l’attention de l’installateurTemps d’installation 1 à 3 heures Dispositions de hotte d’extractionCaractéristiques Table DES MatièresModèles Disponibles DosseretDimensions DU Produit ET Espaces DE Séparation Modèles de cuisinière 121 cmDimensions DE L’APPAREIL ET Espaces Modèles de cuisinière 91 cm 36’’ CaractéristiquesDimensions DE L’APPAREIL ET Espaces Modèles de cuisinière 76 cm 30’’10-1/2 24,13 cm 13/16 2 cm Dosseret 30-36 En option Modèles de cuisinière 76 cm 30’’, 91 cm 36’’ et 121 cm28-1/4 70,96 cm Jusquà lavant de la porte KIT Haute Altitude WB28K10553 KIT DE Réduction DES Caractéristiques Nominales WB28K10554Matériel Fourni Outils NécessairesPréparation de l’installation Emplacement DES AlimentationsAlimentation de gaz Alimentation électriqueInstallation DU Cordon ’ALIMENTATION 3 Fils Installation DU Cordon ’ALIMENTATION 4 FilsNE retirez PAS le branchement du conducteur de terre Étape 1 Sortez L’APPAREIL DE SON Emballage Pour retirer lales portesAttaches Rainure Verrou de charnièreSoulevez la plinthe du socle en mousse Étape 2 Déplacez LA Cuisinière À L’INTÉRIEURPlinthe Vis à bois Pièces du support anti-basculement fourniesVis à tête hexagonale Nécessaires, 1 de Rechange Équerre Assurez-vous que le gaz est coupé ’utilisez pas de flamme pour vérifier les fuites de gazÉtape 7 Ajustez LE Niveau DE LA Cuisinière Étape 7 Ajustez LE Niveau DE LACuisinière suite Étape 8 Replacez Lales Portes DU FourÉtape 9 Vérifiez LES Brûleurs Terminez L’INSTALLATIONCouvercle d’aération de la plaque chaufffante Bas de ACCESSOIRES-PLINTHE fourniePlinthe Poussez Accessoires EN OPTION-DOSSERET DE 30 CM 12 DE Hauteur Installez LE Dosseret 30 CMAvertissement Ce dosseret Ce Kit comprendACCESSOIRES-DOSSERET Ajustable 30-36 non fourni Installez LES Panneaux DE Support MuralAvertissement Les panneaux Outils ET Matériel NécessairesInstallez LES Panneaux DE Recouvrement Installez LES PanneauxDE Recouvrement suite Méthode Alternative en cas d’obstruction de l’accès latéralConvertir LE Régulateur Support D’ORIFICEConsignes d’installation pour la conversion de gaz Orifices DE Miijotage ZDP304Miijotage PrincipauxAjustez LES Flammes DU Brûleur Antes DE Comenzar Tiempo de finalización de 1 a 3 horasModelos a gas LP de Modelos a gas natural deModelo a gas LP de 30 ZDP304L Dimensiones Y Espacios DEL Producto Modelos de cocina de GasModelos de cocina de 30 de ancho Información de diseño Dimensiones Y Espacios DEL ProductoModelos de cocinas de 48, 36 y Información de instalación KIT DE Reducción WB28K10554Materiales Provistos Herramientas RequeridasPreparación para la instalación Ubicaciones DEL Suministro DE EnergíaSuministro de gas Suministro eléctricoInstalación DE Cable DE Energía DE 3 Hilos Instalación DE Cable DE Energía DE 4 HilosNo Quite la cinta de conexión a tierra Instalación Paso 1 Quite EL EmpaquePara quitar las puertas del horno Quite LAS Puertas DEL Horno SóloPaso 2 Traslade LA Cocina AL Interior Quite la placa de protección de la base de espumaIncline la cocina hacia un lado y quite el bloque de espuma Placa de protecciónPiezas anti-volcaduras provistas Tornillos para maderaPaso 5 Conecte LA Electricidad No utilice una llama para verificar pérdidas de gasAjuste DE LAS Patas Delanteras Paso 7 Nivele LA CocinaTornillo de apriete manual Paso 9 Controle LOS Quemadores Finalice LA InstalaciónVuelva a chequear los pasos Tapa de ventilación de la planchaParte inferior de la Accesorios Placa DE Protección ProvistoPlaca de protección Presione Accesorios Opcionales Salpicadero Alto DE Instale EL Salpicadero DEHerramientas Y Materiales Requeridos Este kit incluyeAccesorios -SALPICADERO Ajustable DE 30 a 36 no incluido Advertencia Los panelesLea estas instrucciones por completo y con detenimiento Instale LOS Paneles DE Cubierta Instale LOS Paneles DE CubiertaInstale Instale El tornillo Instale tornillos en las esquinasConvierta EL Regulador Herramientas Necesarias Para LA ConversiónCambie LOS Orificios DE LOS Quemadores Los orificios y convertir el regulador de presiónInstrucciones de instalación para conversión de gas Cambie LOS OrificiosDE LOS Quemadores Cambie EL Orificio DE LA Parrilla si correspondeCambie EL Orificio DE LA Ajuste la configuración de la hilera superiorPlancha si corresponde GE Consumer & Industrial

Range specifications

The GE Monogram Range stands as a pinnacle of luxury and functionality in the realm of kitchen appliances. Designed for culinary enthusiasts and home chefs alike, this range embodies superior performance, cutting-edge technology, and exquisite craftsmanship. One of the main features of the GE Monogram Range is its impressive cooking power, with true European convection that ensures even baking and precise temperature control, making it ideal for a wide array of cooking techniques.

Equipped with powerful burners, including a 20,000 BTU tri-ring burner, the GE Monogram Range offers versatility for both high-heat searing and low-simmer sauces. The ranges typically feature a combination of gas burners, electric ovens, and induction cooktops, catering to diverse cooking preferences. The gas models provide instant heat adjustments, while the induction options offer faster cooking times and enhanced energy efficiency.

The technology embedded in the GE Monogram Range enhances the cooking experience significantly. With smart technology integration, users can connect the appliance to their smartphones for remote control and monitoring via the GE Appliances app. This feature allows cooks to preheat the oven, adjust cooking temperatures, and even set timers from anywhere in their home.

Another hallmark of the GE Monogram Range is its customizable design. Available in various finishes, including stainless steel and bold colors, these ranges can seamlessly blend into any kitchen aesthetics. The option to select additional features, such as griddle plates and customizable backguards, provides homeowners with the ability to tailor their range to their specific culinary desires.

The self-cleaning feature of the GE Monogram Range is yet another advantage, utilizing high-temperature cleaning that incinerates debris and leaves behind only a fine ash, which can be easily wiped away. This makes maintenance straightforward and keeps the range looking pristine.

Safety is also paramount, with features like a gas safety shut-off valve, which provides peace of mind for families. Additionally, the ranges are equipped with advanced oven controls that include a delay bake option, allowing users to schedule baking to start automatically.

In summary, the GE Monogram Range is a true embodiment of luxury, efficiency, and modern technology, catering to the needs of discerning home chefs. With its standout features and adaptable design, it not only elevates kitchen aesthetics but also transforms cooking into an effortless and enjoyable experience.
Top Page Image Contents