GE Monogram Range ACCESSORIES-30 to 36 Adjustable Backsplash not included

Page 19

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation

ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)

WARNING:

To prevent ignition of combustible materials, the entire back wall above the range must be protected by a backsplash constructed of non-combustible material.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT: Save these instructions for local inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.

NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.

NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference.

This backsplash adjusts to fit the space between the top of the range and the bottom of the hood, from 30" Min. to 36" Max. height.

Maximum shelf load-bearing weight is 40 lbs.

TOOLS AND MATERIALS REQUIRED

Gloves to protect against sharp edges

T-15 and #2 Phillips screwdrivers

• Drill with 3/32" and 9/64" bits

Top Wall

Support

Safety glasses

 

Level

Top Cover

 

Pencil

with Shelf

 

This Kit Includes

Top wall support

 

Bottom wall support

Bottom Cover

• Top cover with shelf

 

Bottom cover

Bottom Wall Support

Hardware package with

 

9 Stainless Steel Torx 15 #8 self-tapping screws

– 9 Phillips #2 pan head wood #10 screws

– 3 Stainless Steel #2 truss head

Hardware

#10 screws (for alternatePackage installation method)

INSTALL THE WALL SUPPORT PANELS

WARNING: The wall support panels must be securely fastened to the wall. Failure to do so could result in damage or personal injury.

IMPORTANT: This backsplash is designed to cover the wall between the bottom of the hood and the top of the range. The vent hood should be installed over the rangetop or range before installing this backsplash.

Install and level the Range/Rangetop according to the product installation instructions.

Remove backsplash packaging and protective film.

Locate wall studs on each side. Where studs are not available, plan to use wall anchors (not provided).

Use a level to pencil 2 horizontal lines on the wall,

one 1/8" below the vent hood and the other 1/8" above the Range/Rangetop. This 1/8" space allows the cover panels to overlap the wall supports.

Secure the top wall support panel to the wall with 4 wood screws, through the outermost studs.

Use 4 wood screws to secure the bottom wall support panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels will be covered by the top cover with shelf.

 

Secure the top

 

panel to the wall

1/8

with 4 wood

screws

 

Center

Wood

Secure

Arrow

Screws

the bottom panel

Wood Screws

 

to the wall with

1/8

 

4 wood screws

 

 

19

Image 19
Contents Instrucciones de instalación Instructions d’installationRead these instructions completely and carefully Installation InstructionsVent hood Combinations Completion Time 1 to 3 hoursModels Available ContentsBacksplash Accessories Design InformationRange Models Design InformationTo 4-3/4 Toekick/leg Height Minimum To Adjacent Wall Above the range and below Wide Range Models48, 36 and 30 Range Models Product Dimensions and ClearancesMaterials Provided Installation InformationWB28K10553 High Altitude KIT WB28K10554 DE-RATE KITGas Supply Installation PreparationPower Supply Locations See 3-wire power cord installation on the nextDo not remove the ground strap connection Wire Power Cord InstallationRemove Packaging InstallationTo remove the oven doors Tilt the range to lower the hand-truck wheels off the skid Move the Range IndoorsTilt the range forward on the skid Lift the toekick out of the foam baseAnti-Tip Bracket Anti-Tip Brace Aham Anti-Tip Safety BrochureAnti-Tip Parts Provided Hex Screws Anti-Tip Brace Alternate Brace PositionAssure that gas supply is turned off at the shut-off valve Connect Range to GASRoll Range Into Position Connect ElectricalLevel the Range Front LEG AdjustmentRear LEG Adjustment Level the RangeRecheck Steps Finalize InstallationInstallation Checklist Check BurnersTop Toekick Bottom ACCESSORIES-TOEKICK providedToekick Push This Kit Includes Optional ACCESSORIES-12 High BacksplashInstall 12 Backsplash Tools and Materials RequiredInstall the Wall Support Panels ACCESSORIES-30 to 36 Adjustable Backsplash not includedMaximum shelf load-bearing weight is 40 lbs Alternate Method When side access is blocked Install Cover PanelsInstall Cover Panels See alternate method if side access is blockedTools YOU Needed for Conversion Convert the RegulatorChange Burner Orifices ZDP364, ZDP366, ZDP484, ZDP486 Installation Instructions for Gas ConversionChange Burner Orifices Change Grill Orifice if presentChange Griddle Orifice if present Adjust Burner FlamesDispositions de hotte d’extraction Consignes d’installationRemarque à l’attention de l’installateur Temps d’installation 1 à 3 heuresDosseret CaractéristiquesTable DES Matières Modèles DisponiblesModèles de cuisinière 121 cm Dimensions DU Produit ET Espaces DE SéparationModèles de cuisinière 91 cm 36’’ Caractéristiques Dimensions DE L’APPAREIL ET EspacesModèles de cuisinière 76 cm 30’’ Dimensions DE L’APPAREIL ET Espaces10-1/2 24,13 cm 13/16 2 cm Dosseret 30-36 En option Modèles de cuisinière 76 cm 30’’, 91 cm 36’’ et 121 cm28-1/4 70,96 cm Jusquà lavant de la porte Outils Nécessaires KIT Haute Altitude WB28K10553KIT DE Réduction DES Caractéristiques Nominales WB28K10554 Matériel FourniAlimentation électrique Préparation de l’installationEmplacement DES Alimentations Alimentation de gazInstallation DU Cordon ’ALIMENTATION 3 Fils Installation DU Cordon ’ALIMENTATION 4 FilsNE retirez PAS le branchement du conducteur de terre Rainure Verrou de charnière Étape 1 Sortez L’APPAREIL DE SON EmballagePour retirer lales portes AttachesSoulevez la plinthe du socle en mousse Étape 2 Déplacez LA Cuisinière À L’INTÉRIEURPlinthe Vis à bois Pièces du support anti-basculement fourniesVis à tête hexagonale Nécessaires, 1 de Rechange Équerre ’utilisez pas de flamme pour vérifier les fuites de gaz Assurez-vous que le gaz est coupéÉtape 8 Replacez Lales Portes DU Four Étape 7 Ajustez LE Niveau DE LA CuisinièreÉtape 7 Ajustez LE Niveau DE LA Cuisinière suiteÉtape 9 Vérifiez LES Brûleurs Terminez L’INSTALLATIONCouvercle d’aération de la plaque chaufffante Bas de ACCESSOIRES-PLINTHE fourniePlinthe Poussez Ce Kit comprend Accessoires EN OPTION-DOSSERET DE 30 CM 12 DE HauteurInstallez LE Dosseret 30 CM Avertissement Ce dosseretOutils ET Matériel Nécessaires ACCESSOIRES-DOSSERET Ajustable 30-36 non fourniInstallez LES Panneaux DE Support Mural Avertissement Les panneauxMéthode Alternative en cas d’obstruction de l’accès latéral Installez LES Panneaux DE RecouvrementInstallez LES Panneaux DE Recouvrement suiteSupport D’ORIFICE Convertir LE RégulateurPrincipaux Consignes d’installation pour la conversion de gazOrifices DE Miijotage ZDP304 MiijotageAjustez LES Flammes DU Brûleur Tiempo de finalización de 1 a 3 horas Antes DE ComenzarModelos a gas LP de Modelos a gas natural deModelo a gas LP de 30 ZDP304L Dimensiones Y Espacios DEL Producto Gas Modelos de cocina deModelos de cocina de 30 de ancho Información de diseño Dimensiones Y Espacios DEL ProductoModelos de cocinas de 48, 36 y Herramientas Requeridas Información de instalaciónKIT DE Reducción WB28K10554 Materiales ProvistosSuministro eléctrico Preparación para la instalaciónUbicaciones DEL Suministro DE Energía Suministro de gasInstalación DE Cable DE Energía DE 3 Hilos Instalación DE Cable DE Energía DE 4 HilosNo Quite la cinta de conexión a tierra Quite LAS Puertas DEL Horno Sólo InstalaciónPaso 1 Quite EL Empaque Para quitar las puertas del hornoPlaca de protección Paso 2 Traslade LA Cocina AL InteriorQuite la placa de protección de la base de espuma Incline la cocina hacia un lado y quite el bloque de espumaTornillos para madera Piezas anti-volcaduras provistasNo utilice una llama para verificar pérdidas de gas Paso 5 Conecte LA ElectricidadAjuste DE LAS Patas Delanteras Paso 7 Nivele LA CocinaTornillo de apriete manual Tapa de ventilación de la plancha Paso 9 Controle LOS QuemadoresFinalice LA Instalación Vuelva a chequear los pasosParte inferior de la Accesorios Placa DE Protección ProvistoPlaca de protección Presione Este kit incluye Accesorios Opcionales Salpicadero Alto DEInstale EL Salpicadero DE Herramientas Y Materiales RequeridosAccesorios -SALPICADERO Ajustable DE 30 a 36 no incluido Advertencia Los panelesLea estas instrucciones por completo y con detenimiento Instale El tornillo Instale tornillos en las esquinas Instale LOS Paneles DE CubiertaInstale LOS Paneles DE Cubierta InstaleLos orificios y convertir el regulador de presión Convierta EL ReguladorHerramientas Necesarias Para LA Conversión Cambie LOS Orificios DE LOS QuemadoresCambie EL Orificio DE LA Parrilla si corresponde Instrucciones de instalación para conversión de gasCambie LOS Orificios DE LOS QuemadoresCambie EL Orificio DE LA Ajuste la configuración de la hilera superiorPlancha si corresponde GE Consumer & Industrial

Range specifications

The GE Monogram Range stands as a pinnacle of luxury and functionality in the realm of kitchen appliances. Designed for culinary enthusiasts and home chefs alike, this range embodies superior performance, cutting-edge technology, and exquisite craftsmanship. One of the main features of the GE Monogram Range is its impressive cooking power, with true European convection that ensures even baking and precise temperature control, making it ideal for a wide array of cooking techniques.

Equipped with powerful burners, including a 20,000 BTU tri-ring burner, the GE Monogram Range offers versatility for both high-heat searing and low-simmer sauces. The ranges typically feature a combination of gas burners, electric ovens, and induction cooktops, catering to diverse cooking preferences. The gas models provide instant heat adjustments, while the induction options offer faster cooking times and enhanced energy efficiency.

The technology embedded in the GE Monogram Range enhances the cooking experience significantly. With smart technology integration, users can connect the appliance to their smartphones for remote control and monitoring via the GE Appliances app. This feature allows cooks to preheat the oven, adjust cooking temperatures, and even set timers from anywhere in their home.

Another hallmark of the GE Monogram Range is its customizable design. Available in various finishes, including stainless steel and bold colors, these ranges can seamlessly blend into any kitchen aesthetics. The option to select additional features, such as griddle plates and customizable backguards, provides homeowners with the ability to tailor their range to their specific culinary desires.

The self-cleaning feature of the GE Monogram Range is yet another advantage, utilizing high-temperature cleaning that incinerates debris and leaves behind only a fine ash, which can be easily wiped away. This makes maintenance straightforward and keeps the range looking pristine.

Safety is also paramount, with features like a gas safety shut-off valve, which provides peace of mind for families. Additionally, the ranges are equipped with advanced oven controls that include a delay bake option, allowing users to schedule baking to start automatically.

In summary, the GE Monogram Range is a true embodiment of luxury, efficiency, and modern technology, catering to the needs of discerning home chefs. With its standout features and adaptable design, it not only elevates kitchen aesthetics but also transforms cooking into an effortless and enjoyable experience.