Miscellaneous Machine Setups
3.Press 
to accept the value or 
to retain the previous value.
Figure 19: M2 after Purge Shot Size Prompt
4.Press 
or 
to enter the purge shot size (in grams). Enter a number with at least as much volume as the mixer.
5.Press 
to accept the value or 
to retain the previous value.
6.Press 
twice to return to the Run screen. Activating the purge timer automatically activates the
purge alarm 
. This is the amount of time before the purge timer reaches zero that the machine will sound a warning beep to signaling that it is about to take a purge shot. To change the Purge Alarm value;
From the Run screen, press 
, then press 
, and then press 
once. The following screen will be displayed.
Figure 20: M2 after Purge Alarm Selection
1.Press 
.
2.Press 
or 
to enter the purge alarm duration (in seconds). The minimum value is 2 seconds, and a maximum of 59 seconds or the value of the purge timer if the timer is more than 59 seconds.
3.Press 
to accept the value or 
to retain the previous value.
4.Press 
twice to return to the Run screen.
Cycle Counter and Silent Mode Control (M3)
Resetting the Cycle Counter:
The cycle counter shown on the Run screen, see Figure 6, shows the number of pump cycles since the last time the cycle counter was reset. To reset the cycle counter:
From the Run screen, press 
, then press 
, and then press 
2 times. The following screen will be displayed.
Figure 21: M3 Cycle Counter and Silent Mode Control
Key:
ATotal Pump Cycle Counter Value (Not Resettable)
BResettable Cycle Counter Value
CCurrent Silent Mode State ICON
Silent Mode Off
Silent Mode On
DReset Cycle Counter ICON
EToggle Silent Mode ICON.
IScreen Number (M3)
J
& 
keys will navigate to adjacent screens.
1.Press 
.
2.Press 
to accept the value or 
to retain the previous value.
3.Press 
twice to return to the Run screen.
Silent Mode Operation:
The default setting is 
, Silent Mode Off, where audio feedback is provided when a valid key (1 short tone), or an invalid key (3 short tones) is pressed.
In 
, Silent Mode On, audio feedback is not provided. Silent Mode On has no effect on the audio sounds provided for the purge timer alarm, an error code, or when power is initially applied to the machine.
To toggle or change the silent mode:
From the Run screen, press 
, then press 
, and
then press 
2 times. Screen M3, see Figure 21, will be displayed.
1.Press 
or 
.
2.Press 
to accept the change or 
to retain the previous setting.
3.Press 
twice to return to the Run screen.
312393G | 18 of 50 |