Russound CAV6.6-S2 instruction manual Initial Install Test

INSTALLER

INITIAL INSTALL TEST

Before proceeding to the system programming section, it’s important to conduct an initial test to determine that the hardware components are working properly.

1.Connect the speaker wires from Zone #1 to the CAV6.6 Zone #1 speaker output connectors.

2.Connect an UNO-S2 keypad to Keypad Port #1 on the rear of the CAV6.6.

3.Connect a source to the Source #1 Input on the CAV6.6 using RCA A/V patch cables.

4.Plug a supplied 845.1 IR emitter into the Source #1 IR Output Jack and adhere the emitter end to the source equipment’s IR window.

5.Plug in the main power cords for the CAV6.6 and the source.

6.Turn on the main power switch on the CAV6.6 and the source.

7.Manually command the source to provide audio or use the source remote control.

8.Press the power button on the UNO-S2 keypad and select Source #1.

Congratulations – you should now hear the source through the speakers in Zone #1. Now that you have confirmed the hardware operation, you can proceed to System Programming to set up keypad source control.

If there is no sound, follow these diagnostic steps:

1.Check the source to see that it is operating properly.

2.Check the RCA A/V cable connections from the source to the Source #1 Input on the CAV6.6.

3.Check the speaker connections and verify that they are correct and are connected to the Zone #1 speaker outputs.

4.Check to see that the keypad is connected to the Zone #1 Keypad Port and verify the CAT-5 is properly terminated at both ends.

If none of these steps produce successful results, call Russound Tech Support for further assistance.

48