Russound CAV6.6-S2 instruction manual Macro, Save CHANGES?

INSTALLER

INSTALLATION MENU

Numeric IR (cont’d)

	i. MACRO -	Macro loads a series of commands which are processed when
	(Macro)	activated.
	ii. MACRO ID –	Enter the macro ID number. Menu advances to SAVE CHANGES
	(MacID)	(step 13)
	e. All Other Selections:	Procedure advances to DEVICE CODE (step 11)
11.	DEVICE CODE –	Source component code for IR control.
	(DevCd)
12.	KEY FUNCTION –	Select a function (Enter, Play, etc.).
	(KeyFn)
13.	SAVE CHANGES? –	Select “yes” to save the changes.
	(Save?)

SRC SEL CMD (SrcSC)

This procedure permits a command to be sent to the source component when the source component is initially selected. See Source Setup Menu on Page 55 and Source Select Command & # Of

Sources - Flow Chart on page 71

1. SOURCE NUM –	Select the source number this command will be configured for.
(Src #)
2. COMMAND TYPE –	Select the type of source command (e.g., CD, TV, etc.).
(CmdTp)
a. Selected: Learned IR	Choose Learned IR if the pre-programmed IR code library does
(LrnIR)	not support the source component.
i. LEARNED SRC –	Select the learned source bank to be assigned to the source
(LnSrc)	component. Procedure advances to KEY FUNCTION (step 4)
b. Selected: Unassigned	The source select command is cleared. Procedure advances to
(Unasg)	SAVE CHANGES (step 5)
c. Selected: Default	Default selects the same device type and device code previously
(Deflt)	setup in BASIC SETUP. Procedure advances to KEY FUNCTION
	(step 4)
d. Selected: Macro:	(To build macros, see Macro Editor page 65)
i. MACRO -	Macro loads a series of commands which are processed when
(Macro)	activated.
ii. MACRO ID –	Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID)	(step 5)

60