Vulcan-Hart GRD65 ML-052082, GRD85 ML-052306, GRC85 ML-052307 Startup with Electronic Igniter

Page 16

STARTUP WITH ELECTRONIC IGNITER

CAUTION: Before turning the burners on, the fry tank must be filled with liquid or melted shortening.

1.Plug the power cord into an appropriate grounded receptacle and turn the main gas valve on.

2.Fill the fry tank with shortening. If using solid shortening, the fryer must be equipped with a melt cycle.

3.Open access door; turn the gas valve extension arm located inside the cabinet door to OFF (Fig. 7). Wait 5 minutes for unburned gas to vent.

Fig. 7

4.Turn the gas valve extension arm to ON.

5.Press the power switch on.

6.If pilot fails to light within 90 seconds, press power switch off and repeat steps 3 through 5 until the pilot lights. If the pilot fails to light after several repeated attempts, contact your local Vulcan- Hart Service office.

7.Thirty seconds after the pilot ignites, the fryer begins heating to the programmed fry temperature.

8.When the set temperature is reached, the burners shut off and the set temperature is displayed in the window. The fryer then cycles on and off to maintain the set temperature.

– 16 –

Image 16

Contents

Installation GRD and GRC Series GAS Fryers Important for Your Safety For Your SafetyTable of Contents Table of Contents Specifications GeneralOptions and Features Battery ConfigurationsNon Filter Models C DFilter Fryer Dump Fryer Fryer Fryer Fryer Dump Fryer Filter Fryer Fryer Fryer DumpFIELD-INSTALLED Accessories FACTORY-INSTALLED Options RO Series Frymate FeaturesGR Series Frymate Dump Station Heat Lamp TopsInstallation UnpackingInstallation Codes and Standards LocationUnited States of America CanadaFryers Mounted on Legs Non-Batteried Fryers AssemblyFryers Mounted on Casters GAS Connections Testing the GAS Supply Piping System GAS Pressures and Orifices Flue Connections Leveling FryerElectrical Connections Operation Before First USESeasoning Filling FRY Tank with ShorteningLighting Instructions for Manual Pilot Ignition Fig Startup with Electronic Igniter Controls GRD SeriesControl Guide Programming Programming GuideMelt Options GRD Series Shutdown Models With Basket Lift OptionExtended Shutdown GRC Series Parameter Steps Left Display Right Display Set Back Heating Melt L Melt S Melt Options GRC SeriesDispose Temperature Temperature and Time ProgrammingTime Advanced Time Features Setting Advanced Time Features Time Programming Quick Chart Shutdown Fry Basket Guidelines Frying Guidelines All ModelsRecommended Basket Capacities Filtering Guidelines All Models Daily FilteringFilter-Ready Fryers For Use With Mobile Filter Only Battery Interplumbing Only Available on KleenScreen Models Filtering Procedures Non-Filter-Ready FryersHigh Limit Device All Models Drain Interlock GRD and GRC SeriesDaily CleaningWeekly or AS Required Maintenance ServiceLubrication VentTroubleshooting Guide Symptom Possible CausesAlarms and Error Messages GRD and GRC Series Pilot OUT