Installation Instructions
WALL-MOUNTED INSTALLATION—VENTED TO THE OUTSIDE
2 INSTALL MOUNTING BRACKET
This vent hood must be secured to the horizontal support or wall studs.
•With the template taped in place, use a punch to mark all mounting screw locations.
•Drill 1/8” pilot holes at the 6 punched locations.
•Remove the template.
•The 2 holes in the support bracket holes must enter studs or the horizontal support.
•Use wood screws to secure the mounting bracket to the wall. The screws must engage wall studs or the installed horizontal mounting support.
•Check to be sure that the bracket is level. There is no way to level the hood after hanging it from this bracket.
3 INSTALL DUCT BRACKET
The duct bracket must be intalled against the ceiling. This bracket will hold the duct cover in place at the top.
Secure the bracket to the ceiling and wall:
•Align the marked centerline on the bracket with the centerline on the wall.
•Mark the 2 screw hole locations in the ceiling.
•Drill 1/8” plot holes in the marked locations.
•If pilot holes do not enter studs, enlarge the holes to 3/8” and install wall fastener anchors.
•Drive screws, by hand, into the fasteners to allow anchors to expand. Remove the screws.
•Secure the bracket to the ceiling and wall with wood screws and/or fasteners.
C
L
10