Installation Instructions
WALL-MOUNTED INSTALLATION—RECIRCULATING
4 MOUNT THE HOOD
Install a wood screw | Mounting |
on each side of the | bracket |
mounting frame |
|
•Lift the hood onto the mounting bracket.
•Check to be sure it is level.
•Install wood screws through the hood and into the wall on each side of the mounting bracket.
Install bottom
mounting
screws
•Extend the canopy forward for better access to the rear mounting screw holes.
•Install 2 wood screws or fasteners through the bottom of the hood into the wall.
5SIZE AND CUT DUCT PIECE
•Hold upper air deflector with duct connector against the
ceiling.
•Measure from the bottom of
the air deflector to the top of |
| |
the hood as shown. Reduce |
| |
that dimension by 1” to |
| |
facilitate installation. |
|
|
The duct will cover |
| Duct length |
and overlap the | Measure | |
deflector and the |
| |
length |
| |
hood outlets. |
| |
|
| |
5SIZE AND CUT DUCT PIECE (cont.)
•Cut the duct piece to size and slip onto the bottom of the duct
connector.
•Use duct tape to seal and secure
the duct piece to the connector.
•Place the assembly over the hood outlet.
• Hold the assembly against the ceiling. The penciled centerline should show through the slot in the deflector. Mark the screw holes on the sides of the assembly.
• Remove the assembly and drill 1/8” pilot holes into the wall studs.
•Enlarge holes that did not enter studs to 3/8” and tap plastic or metal anchors into the holes, flush with the wall.
•Mount the assembly onto the hood outlet, push up against the ceiling and install the screws provided.
CAUTION: Do not use sheet metal screws at the hood flange connection. Doing so will prevent proper damper operations. Seal connection with tape only.
ATTENTION : N’utilisez pas de vis autotaraudeuses pour connecter le rabat de la hotte. En utilisant des vis, vous empêchez le bon fonctionnement du volet de fermeture. Scellez la connection uniquement avec du ruban adhésif.
16