Installation Instructions
UNDER-CABINET INSTALLATION
1INSTALL FRAMING FOR HOOD SUPPORT
IMPORTANT: Framing must be capable of supporting 100 lbs.
View from rear
cleats
1” x 6” min.
mounting
support
Centerline of
installation
space
If drywall is present, mark the screw hole locations for the top mounting brackets. Remove the template.
•Cut away enough drywall to expose 2 vertical studs at the bracket location indicated on the template.
•Install a horizontal support at least 1” x 6” between two wall studs at the top bracket installation location.
The horizontal support must be flush with the room side of the studs. Use cleats behind both sides of the support to secure to wall studs.
•Reinstall drywall.
2PREPARE THE HOOD
•Remove the hood from the box. Remove packaging and tape.
Electrical | Remove 2 side |
cover screws | |
panel |
|
•Remove one screw on each side of the cover on the electrical panel. Lift off the cover and set aside with screws.
Junction box |
Inside screw |
Secure |
electrical panel |
with 3 screws |
•Stand the electrical panel upright.
•Align the screw holes in the bottom of the panel with the holes on the base of the hood at the front side.
•Install 3 screws provided.
• Snap the damper into the |
| |
Install | ||
exhaust outlet on the top of | ||
damper | ||
the hood. | ||
| ||
|
20