GE ZV800 installation instructions Contents, Product Dimension and Clearance Installation Options

Design Information

CONTENTS		Wall-Mounted Installation – Recirculating
Design Information		Ductwork, Wiring Locations	14
		Step 1, Install Framing for Hood Support	14
Product Dimensions and Clearances	3
Installation Options	3	Step 2, Install Mounting Bracket	15
Advance Planning, Ductwork, Framing	4	Step 3, Prepare the Hood	15
Power Supply	4	Step 4, Mount the Hood	16
Duct Fittings	5	Step 5, Size and Cut Duct Piece	16
		Step 6, Connect Electrical	17
Installation Preparation
		Step 7, Install Duct Covers	17
Tools and Materials Required	6
		Step 8, Install Filters	18
Remove the Packaging	6
		Step 9, Finalize Installation	18
Wall Mount Installations	7
		Under-Cabinet Installation
Installation Below a Wall Cabinet	7
		Cabinet Requirements	19
Check Installation Hardware	8
Ductwork, Wiring Locations	9	Ductwork, Wiring	19
		Step 1, Install Framing for Hood Support	20
Wall-Mounted Installation – Vented to the Outside
		Step 2, Prepare the Hood	20
Step 1, Install Framing for Hood Support	9
		Step 3, Cut the Opening	21
Step 2, Install Mounting Bracket	10
		Step 4, Install Side “L” Brackets	21
Step 3, Install Duct Bracket	10
		Step 5, Remove Side Screw	21
Step 4, Prepare the Hood	11
		Step 6, Mount the Hood	22
Step 5, Mount the Hood	11
		Step 7, Complete Installation and Connect Ductwork	22
Step 6, Connect Ductwork	12
		Step 8, Connect Electrical	23
Step 7, Connect Electrical	12
		Step 9, Install Rear Mounting Screws	23
Step 8, Install Duct Covers	13
		Step 10, Install Filters	23
Step 9, Install Filters	13
Step 10, Finalize Installation	13

PRODUCT DIMENSION AND CLEARANCE

INSTALLATION OPTIONS

*Height to Ceiling

1-1/2”

12-15/16” at Sides,

13-11/16” at Center

NOTE: The vent hood canopy extends forward 5-7/8”.

35-7/8”

*The Supplied Duct Cover Fits 8 ft. to 10 ft. Ceiling Heights

24” Min.

30” Max.

WALL-MOUNTED INSTALLATIONS

This hood may be installed onto a wall and vented to the outdoors, or it can be installed for recirculating operation. All necessary parts for a recirculating operation are shipped with the hood. No kits required.

*24” Min.

The vent hood must be installed 24” min., and 30” max. above the cooking surface. The telescopic duct cover conceals the ductwork running from the top of the hood to the ceiling.

The duct cover is sized to reach 8 ft. to 10 ft. ceiling heights.

The hood installation height, from the cooking surface to the bottom of the hood, depends upon ceiling height.

*Depending on Cabinet Height

UNDER-CABINET INSTALLATIONS

The hood may be installed beneath a cabinet. The cabinet must measure at least 20” from the bottom frame to the inside top. See page 19.

•Both vented and recirculating operation can be accomplished in an under-cabinet installation. (Custom cabinet modification is required for recirculating operation.)

3