SURFACE BURNER MODULE
To Install Burner Module | To Remove Burner Module | |
|
|
|
|
|
|
1.Be sure all control knobs are turned off.
2.If the grill burner grates are in place, remove them before installing a surface burner module. Clean burner basin of any grease accumulation. See the Care and Cleaning section.
3.Position the burner assembly with the mixer tube openings toward the orifices. Slide the burner assembly toward the orifices until the opening for the igniter is over the igniter. Lower into place until the side openings are resting on the burner supports and the igniter is centered between the two flash tubes.
4.Install the aeration tray by inserting the prong at the end of the pan into the opening in the end of the burner basin. Lower the opposite end into the cooktop.
NOTE: Optional surface burner module (JXGB89) can replace the grill burner. Burners supplied with cooktop (JGP389) and optional module air shutters have been adjusted for compatibility on both sides.
1.The control knobs should be in the OFF position and the cooktop should be cool.
2.Remove the aeration tray by lifting up the front end on the right side (back end on the left side) until the top clears the opening of the cooktop by about 5 inches.
3.Hold aeration tray by the sides and slide away to remove the prong from the opening and clear the surface burners.
4.Lift up on the sides of the surface burner assembly bracket about 2 inches. Slide away from the orifices.
NOTE: If you have cooktop JGP389, you can purchase another
10