GE GLD8000 Series, CDW9000 Series Flashing display lights, Recommended dishwasher products, Clean

Page 7

ge.com

5Start (continued)

PDW9000 Series

After selecting the cycle and desired enhancements, touch the START/RESET pad to ready the dishwasher to begin the cycle. Close the door to start the cycle or begin the DELAY START countdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.

The dishwasher will always display your last selection and enhancements. If you don’t want to change the settings, simply touch the START/RESET pad to ready the dishwasher and close the door to begin the cycle.

Also, if a power failure occurs NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the new cycle.

When the door is opened, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate the display, open and close the door or touch any pad.

6Clean

PDW8000 Series and GLD8000 Series

The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until a pad is pressed or the door is opened and then closed.

PDW9000 Series and CDW9000 Series

The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete. You may remove the dishes at any time. The high-efficiency fan will run quietly for 30 minutes to 4 hours (depending on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. The fan can be turned off by opening the door and pressing any keypad.

ALL MODELS: To turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off), press the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.

Flashing display lights.

Status Indicator Lights

What It Means

START/RESET

Cycle has been interrupted by pressing the START/RESET pad, or there

 

has been a power failure. Light will stop flashing after the dishwasher

 

automatically drains out the water. The dishwasher will restart if the

 

interruption was the result of a power failure.

Recommended dishwasher products.

Safety Instructions

Operating Instructions

Troubleshooting Tips

GE recommends the following products for use in its dishwashers:

■For your manual detergent dispenser, Cascade® and Electrasol® powder, liquid or gel automatic dishwasher detergents are approved.

■For your SmartDispenseTM Detergent Dispenser, use only the recommended detergents listed on page 10 of this manual.

■Jet Dry® or Cascade Crystal Clear® rinse agents to remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic. Using rinse agent also improves dry performance.

■Cascade® Plastic BoosterTM to remove red staining inside your dishwasher that can come from some tomato-based foods.

■Cerama Bryte® Stainless Steel Appliance Cleaner to clean the exterior stainless steel panel of GE and ProfileTM dishwashers (for stainless steel exterior models only).

7

Consumer Support

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Loading the Racks 12-14 Write the model and serial numbers here Model # Serial #You can find them on the tub wall just inside the door On prior to use Troubleshooting TipsOperating Instructions Consumer SupportGe.com SupportOperating Instructions ConsumerAbout the dishwasher control panel Control SettingsSafety Instructions Troubleshooting Tips Consumer SupportMedium 7.5 gal., 95 min Light 6.3 gal., 85 min ANTI-BACTERIA Heavy 8.8 gal., 105 minNormal Wash Heavy 8.8 gal., 70 min Start EnhancementsPDW8000 Series and GLD8000 Series Recommended dishwasher products CleanStatus Indicator Lights What It Means Flashing display lightsDish Preparation Prior to Loading Using the dishwasherCheck the Water Temperature Use Jet-Dry or Cascade Crystal Clear Rinse AgentFilling Manual Detergent Dispenser SafetyManual Detergent Dispenser InstructionsSmartDispenseTM Detergent Dispenser some models Troubleshooting TipsSet the door at a comfortable angle to fill the dispenser Top controls Determine the Hardness of Your Tap WaterFront controls Close and latch the door lights on, dishwasher not runningLoading the dishwasher racks Troubleshooting Tips SupportConsumer Then fill the lower rack and begin your cycle SafetyRemoving the Upper Rack Silverware BasketExtra Rack Features on some models Loading place settings…Caring for the dishwasher Problem Possible Causes What To Do Before you call for service…Safety Instructions Operating Instructions Error Messages Possible Causes What To DoMake sure inlet water temperature is at least 120F Flatware Make sure water temperature is at least 120FCycle that will get them clean Touch the START/RESET pad again. Repeat if necessaryWater won’t pump Go off when you’reSetting controls Water standing Control panel lightsPage Page Benefits Include With Service Protection Plus you can expect3Serial Number Consumer Product Ownership RegistrationWarrantor General Electric Company. Louisville, KY GE Dishwasher WarrantyOperating For The Period GE Will ReplaceConsumer Support Lave-vaisselle Conseils de dépannage Instructions de FonctionnementSoutien au consommateur Avant de jeter votre vieux lave-vaisselle Fonctionnement Instructions deConseils de dépannage Soutien au ConsommateurSoutien au consommateur Conseils de dépannage Le panneau de contrôle du lave-vaisselleRéglage des contrôles Instructions de sécuritéChoix Conseils de dépannage Soutien au consommateurOptions Conseils de dépannage Soutien Produits de lavage de vaisselle recommandésVoyants lumineux qui clignotent Au consommateurVous avez oublié de la vaisselle? Utilisation du lave-vaisselleVérifiez la température de l’eau Préparation de la vaisselle avant son chargementRemplissage du distributeur manuel De détergent Distributeur manuel de détergentDe sécurité De dépannage Soutien au consommateurSoutien au Distributeur de détergent SmartDispenseMD certains modèlesConsommateur Conseils de dépannage InstructionsAprès avoir réglé la dureté de l’eau, appuyez sur Commandes sur le hautTrouvez la dureté de votre eau d’alimentation Le montant optimal de détergentPanier supérieur ajustable Chargement des paniers de votre lave-vaisselleSécurité Panier supérieurEnlèvement du panier supérieur ConsommateurPanier à argenterie Chargement des couverts… Chargement des paniers du lave-vaisselleSoutien Soins de votre lave-vaisselleMessages d’erreur Causes possibles Ce qu’il faut faire Avant d’appeler le service de réparations…Problème Causes possibles Ce qu’il faut faire Du distributeur Eau dans le Voile sur les verresDétergent qui reste Dans les réservoirsDe la cuve En réglant les commandesLe lave-vaisselle Ne fonctionne pasInstructions de fonctionnement Soutien au consommateur Ownership Registration Inscription de propriété de produit de consommation Ce qui n’est pas couvert Garantie GE sur les lave-vaisselleInstructions de sécurité Fonctionnement Pour une période de GE remplaceraProlongation de garantie Soutien au consommateur Service de réparationsPièces et accessoires Studio de conception réaliste
Top Page Image Contents