INSTALLATION
HOW TO INSTALL YOUR OUTDOOR BEER DISPENSER COMPONENTS
ASSEMBLE AND CONNECT PARTS
1 . Screw the black faucet knob onto the faucet (Fig. 06).
2.Mount the draft tower onto the counter top using the four furnished screws and the one mounting gasket (Fig. 07).
3.Attach the elbow to the top of the keg coupler, making sure to use a black washer
(Fig. 08).
4.Attach the beverage line coming from the draft tower to the elbow. Use the black washer inside the hex nut and tighten the beverage line securely with a crescent wrench (Fig. 09).
5.Fasten the CO2 regulator to the CO2 cylinder, tightening the CO2 nut securely. Do not over tighten; overtightening may damage the washer in the stem of the regulator (Fig. 10. Ensure valve is off.
6.Attach one end of the red air hose to the hose barb
on the CO2 regulator, using one of the two snap clamps provided (Fig. 11). Use pliers to snap the clamp tight to assure that there is no gas leak.
7.Place the CO2 cylinder and regulator inside one of the corners of the refrigerator. It is important that the cylinder be kept in an upright position to operate efficiently, using a clain or heavy cord if a wire rack is not provided (Fig. 12).
8.Fasten the other end of the red air line to the keg coupler using the remaining snap clamp (Fig. 13).
Fig. 06
Fig. 08
Fig. 10
Fig. 07
Fig. 09
Fig. 11
Fig. 12 | Fig. 13 |
10