Remote Blower (see Figures 11 and 12 for further detail):
A.Remove junction box cover and connect conduit with 5 wires from remote blower. Hook up wires per Wiring Diagramm.
Fig. 10. Replace junction box cover.
B.Attach duct transition at mounting holes with sheetmetal screws.
C.Feed remote blower pigtail through strain relief.
D.Attach strain relief to downdraft near junction box.
Integral Blower VTN600CV2C (see Figures
10 and 12 for further detail):
E.Connect pigtail to downdraft at 6 pin connector.
F.Run pigtail wires to juntion box.
G.Inside junction box, connect conduit with five wires from remote blower. Use a conduit connector to secure.
Note: Blower and duct transition box may be installed with duct outlet left, down or right. Install blower or duct transition in such a way that access panels can be removed for service.
gure 11 - Remote Blower |
|
|
|
| 6 Pin Connector |
|
| Junction Box |
TTransition |
|
|
CV2T6 | Strain Relief |
|
DHZDHR6 |
| |
| Remote Blower | Conduit To |
| Pigtail | Remote Blower |
Fig. 11 – Remote Blower
17