SafetyInstructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Refrigerator Location
Do not install the refrigerator where the | Install it on a floor strong enough to support it |
temperature will go below 60°F (16°C) because | fully loaded. |
it will not run often enough to maintain proper |
|
temperatures. |
|
Clearances
OperatingInstructions
Allow the following clearances for ease of installation and proper air circulation.
Sides | 0″ (0 mm) |
Top | 1″ (25 mm) |
Back* 11/4″ (32 mm)
*Metal cover on back may touch wall.
If refrigerator is to be installed against a wall on the hinge side, allow a minimum of 13/4″ (45 mm) between the wall and the side of the refrigerator to allow for door and handle clearance.
TroubleshootingTips Installation Instructions
CustomerService
Packaging Tapes
Remove all packaging tapes and
Leveling
Your refrigerator comes with adjustable rollers and | Adjustable legs are located at the front corners. |
adjustable legs. Either rollers or legs should be set so | Turn the adjustable legs clockwise to raise the |
the refrigerator is firmly positioned on the floor and | refrigerator, counterclockwise to lower it. |
the front is raised just enough that the doors close |
|
easily when opened about halfway. |
|
Tilt top out |
|
| Turn adjustment leg clockwise |
| to raise refrigerator |
| Adjustable |
Base Grille | Leg |
| |
To adjust the rollers, tilt the base grille out |
|
exposing the adjustment screws. Using an |
|
adjustable wrench, turn the two front roller |
|
adjusting screws counterclockwise to raise the |
|
refrigerator, clockwise to lower it. |
|
Turn adjusting screw |
|
counterclockwise to raise |
|
refrigerator |
|
Adjustable |
|
Roller |
|
12