Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (on some models)
If the refrigerator has an icemaker, it will have to be | A water supply kit (containing copper tubing, |
connected to a cold water line. | shutoff valve, fittings and instructions) is available |
| at extra cost from your dealer or from Parts and |
| Accessories, |
Refrigerator Location
Do not install the refrigerator where the | Install it on a floor strong enough to support it |
temperature will go below 60°F (16°C) | fully loaded. |
because it will not run often enough to maintain |
|
proper temperatures. |
|
Clearances |
|
Safety Instructions Operating Instructions
Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections:
Sides | 5/8″ (15 mm) |
Top | 1″ (25 mm) |
If built-in, allow 7/8 ″ (22 mm) for hinge covers.
Back 1″ (25 mm)
If the refrigerator is against a wall
on either side, allow the following door clearances for a 90° door
opening:90° 
22′– 26′ models | 3/4″ (19 mm) |
27′ models | 11/2″ (38 mm) |
Installation
Rollers
The rollers have 3 purposes:
1 Rollers adjust so the door closes easily when opened about halfway. [Raise the front about 5/8″ (15 mm) from the floor.]
To assure that the doors will close automatically from a halfway open position, there is a
2 Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
3 Rollers allow you to move the refrigerator away from the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it out at the bottom.
Turn the roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Use an adjustable wrench (3/8″ hex head bolt) or pliers.
To replace base grille, align prongs on back of grille with clamps in cabinet and push forward until grille snaps into place.
Instructions Troubleshooting Tips
Customer Service
17