1.After adjusting the doors, please insert the supplied fastener ( 6 ) using a pliers ( 5 ) in the gap between the
2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04”.
ADJUSTING THE FREEZER DRAWER LEVEL
Adjustment part
Freezer Drawer |
1.Locate the
1
2
2.Loosen the controller screw ( 3 ) with a Phillips
screwdriver(+).
3
3.Find the best level to align the door slope.
•After adjustment, tighten the controller screw ( 3 ) and then philips screws.
Example) The slope is about 0.08inch (2mm) as shown below. - Rotate the height adjuster to
Slope
Reference plane
CHECKING THE WATER DISPENSER LINE
A water dispenser with a fi lter is one of the helpful features on your new refrigerator. To help promote better health, the water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can be fi lled in about 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer. We recommend using a water line installation kit that contains copper tubing and ¼” compression nut.
10_ setting up
2013.3.4 1:32:39 PM |