Samsung RF4287HABP Reattaching the Refrigerator Doors, Disassemble the refrigerator doors

Disassemble the refrigerator doors

Be careful not to drop and scratch the doors WARNING while removing the doors.

Disassemble the refrigerator doors

1.With the door opened, remove the cap top table ( 1 ) with a fl at-blade screwdriver (-), and close the door. Remove the 3 screws holding down the top table ( 2 ) and turn it with several wires connected.

2

1

2.Disconnect one connector ( 3 ) on the right side door and one connector ( 4 ) on the left side door. Remove the water line ( 5 ) while pressing the dark gray color part ( 6 ) of the water line coupler.

	4
Red Clip	3
(1/4")

5

6

If a red clip is on the coupler, it must be CAUTION removed before removing the tube.

3.Remove the 3 hex head bolts ( 7 ) attached to the upper left and right door hinges with a socket wrench (10mm). Remove the ground screw ( 8 ) attached to the upper left and right door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 9 ).

Socket wrench

8

7

9

4.Lift the door straight up to remove.

5.Remove the screw ( 10 ) attached to the lower left and right door hinges with a philips screwdriver (+). Remove the 2 hex head bolts ( 11 ) attached to the lower left and right door hinges with an allen wrench (3/16”). Remove the lower left and right door hinges ( 12 ).

12

10

11

Allen wrench

REATTACHING THE REFRIGERATOR DOORS

To reattach the fridge doors, assemble parts in reverse order.

1.The Water Line must be fully inserted to the center of transparent coupler (Type A) or the Guide Lines (Type B) to prevent water leakage from the dispenser.

2.Insert the clip in the install pack and check that it holds the line fi rmly.

Type A Type B

	Dispenser
Center of Transparent coupler	The Guide Lines
clip A (1/4”)	clip A (1/4”)
(6.35mm)
	(6.35mm)

setting up _07

01 SETTING UP

DA68-01922A.indb 07 2013.3.4 1:32:33 PM