Amana IA 52204-0001 Proper Disposal of your Refrigerator, Cutout Dimensions, Tools Required

!DANGER

Proper Disposal of your

Refrigerator

IMPORTANT: Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous—even if they sit for "just a few days". If you are getting rid of your old refrigerator, please follow the instructions below to help prevent accidents.

BEFORE YOU THROW AWAY YOUR OLD REFRIGERATOR OR FREEZER:

•Take off the doors.

•Leave the shelves in place so children may not easily climb inside.

Cutout Dimensions

IMPORTANT:

•Save all screws for reuse.

•For plug removal requiring use of flat blade screwdriver or putty knife, blade of tool must be covered with masking tape to avoid damage to refrigerator finish. For plugs using a screwdriver or nut driver style head, use appropriate tool to avoid damage to plugs.

!CAUTION

To avoid personal injury or property damage caused by refrigerator tipping, stabilizing leg must be firmly against floor.

Door Reversal (Contour door model)

Only a qualified servicer can reverse this door. To have doors reversed, please call 1-800-843-0304. There is a

fee charged for this service.

Door Reversal (Front mounted handle)

Some installations may require door reversal to achieve full door swing. To reverse door swing direction perform the following steps.

1.Remove refrigerator handle:

•Remove handle screw from top handle trim. Pry up edge of handle trim using a putty knife with the blade covered with masking tape. Remove handle from door by removing 1 remaining mounting screw at each end of handle.

•Remove 1 plug from top hinge side of door and 2 from front hinge side of door. Transfer plugs to opposite side of door to fill empty mounting holes.

A

A

Single Installation

H• 69" with 12" deep cabinets above refrigerator.

• 70" with 24" deep cabinets above refrigerator.

W36" D 24"

Installation Instructions

Proper installation will ensure that this refrigerator operates most efficiently. Amana cannot be responsible for improper installation.

Tools Required
5/	16		" hex nut driver	Phillips screwdriver
3/				Blade screwdriver
	8	" hex nut driver
1/4		" hex nut driver

Putty knife (blade covered by masking tape)

	C	C	B
				D
		A
		A
A	Handle trim		C	Screws
B	Handle		D	Plugs

2.Remove freezer door handle:

•Open freezer door 90°. Locate two notches on back of freezer handle. Insert flat screwdriver blade or putty knife blade wrapped in masking tape. Pry up back edge of handle cap and remove from handle.

•Remove handle from door by removing two mounting screws.

•Remove 2 plugs from hinge side of freezer door and transfer to opposite side to fill holes left from handle removal.

B

C

D

A

A	Handle	C	Screws
3 B	Handle cap	D	Plug