•Some models have an internal support rod(see below) installed in the hinge socket of door. If present, remove and retain for later replacement.
A
A Support rod (some models)
3.Reverse center hinge:
•Remove center hinge bracket and shims by removing screws using a Phillips screwdriver.
•Remove 3 screws opposite of center hinge and transfer to opposite side of cabinet.
•Install bracket on opposite side of cabinet with shims.
| A | C |
| B |
|
A | Phillips screws | C Center hinge shim |
B | Center hinge |
|
4.Reverse bottom hinge pin:
•Remove toe grille by grasping both ends and pulling straight out from unit. Grille snaps free.
•Unscrew door extension on top of door with Phillips screw driver. Flip door extension so notched corner turns in toward interior of door. Reinstall with screws.
A 
C 
B
A | Before | B After |
C | Door extension |
|
6.Reverse handles and trim:
•Remove screws from bottom door cap of refrigerator and freezer door with screwdriver.
•Using a soft rubber mallet, tap bottom of handle upward toward top of door. Handle will slide up approximately ¾" and release from door.
•Using a soft rubber mallet, tap bottom of door hinge trim upward toward top of door. Trim will slide up approximately ¾" and release from door.
•Remove plastic tab on top of trim*. Return tab to literature assembly. Locate alternate tab piece in literature assembly and place this in notch at opposite end of trim.
*In stainless steel models plastic tab is not required. Replace trim with alternate trim shipped with unit.
A
AToe grille
•Exchange hinge pin from bottom hinge assembly with outward hinge plug from opposite bottom hinge assembly.
A 
B
A Hinge pin | B Hinge plug |
5.Remove door stops and reverse door extensions:
•Locate door stop and bottom of refrigerator door and freezer door. Remove with Phillips screwdriver.
AC
|
| B |
A | Bottom door cap | C Door stop |
B | Screws |
|
| Left |
|
|
| Right |
|
|
|
| ||
| mounted |
|
|
| mounted |
| handle |
|
|
| handle |
|
|
|
| ||
|
|
|
| ||
|
|
|
|
|
|
•Replace bottom door cap.
•Attach door stop under the hinge side of the door using Phillips screws.
•Install hinge trim by locating notches on the inside of trim(make sure plastic tab insert is facing bottom of door). Align notches of trim with metal mounting tabs on opposite side of door. Slide trim down until piece locks into place. Tap top of trim with rubber mallet to insure snug fit.
6