Lennox Hearth operation manual SPECIFICATIONS - Model T300P Series

SPECIFICATIONS - Model T300P Series

Flue Size		3” / 76mm Rear
Width, Overall		28 3/4” / 730 mm
Depth, Overall		26 1/2” / 660 mm
Height		28 3/4” / 730 mm
Floor to Rear
Flue Center		8 3/4” / 222 mm
Facing Back of Unit,
Outside Edge of Left Leg
To Center of Rear
Flue Outlet		10 1/2” / 267 mm
Floor to Rear
Outside Air Inlet		10” / 254 mm
Facing Back of Unit
Outside Edge of Left Leg
To Center of Air Inlet		17 1/2” / 445 mm
Floor Protection	+	Front and Sides:6”/152mm
Requirements		Back: Up to 6” / 152mm
Standard Features		Fastfire Self Igniter
		Wall Thermostat
		(wire included)
Hopper Capacity		50 lbs.
Burn time	♦	14-34 hours
Fuse, Control Board		5 amp, 25 volt, 3AG*
Fuse, Igniter		6 amp, 125 volt*
Heat Input (Max.)	♦	13,000-32,000 BTU / hr
Overall Efficiency		85%
Emissions	♦	0.43 gram / hr (varies w/
		size and type of fuel)
		EPA exempt
Ship Weight		363 lbs.
Room Air Blower		150 CFM; 1.5 amps,
		2175 rpm
Auger Motor		1 RPM; .4 amps
Exhaust Blower		95 CFM: 1.0 amps,
		2880 rpm

Note: Dimensions shown are approximations only (+/- ¼”)

BACK VIEW

28 3/4”

8 3/4” 10 “

10 1/2”

17 1/2”

SIDE VIEW

26 1/2”

28 3/4”

Face of door opening to stove back

23”

+Non-combustible thermal rated floor protection must be used when installed on carpet (see Floor Protec- tion, page 5). When installed at clearances less than 6”, the floor protector is only required to ex- tend to the wall.

♦Fuel delivery and burn times will vary depending on size and type of fuel used. Estimated heat in- put based on fuel value of 8400 BTU per lb.

* Fuses are rated as fast blow.

Page 26