Lennox Hearth T300P operation manual Thermostat Installation, Terminal Block for Thermostat

INSTALLATION

THERMOSTAT INSTALLATION:

NOTE: Always Disconnect Power Before Perform- ing The Thermostat Installation.

A 24-volt wall thermostat and 20 feet of 18-gage ther- mostat wire is included in your stoves accessory pack- age. It is recommended that the thermostat and ther- mostat wire be installed by an authorized Lennox Hearth Products dealer.

Installation Steps:

1.Unplug stove power cord from the wall outlet.

2.Locate the thermostat terminal block (see illustra- tion).

3.Loosen the two terminal screws on the terminal block and remove the jumper.

4.Connect the two wires from your thermostat to the terminals (one per terminal). Ensure that the purple wires from the harness remain connected to the ter- minal block and tighten the terminal screws. Make sure the wires are firmly connected to the thermo- stat.

5.Plug in the stove and you are ready to operate with your thermostat!

IMPORTANT: IF THE WALL THERMOSTAT PRO- VIDED IS NOT USED, THE JUMPER IS REQUIRED FOR THE STOVE TO OPERATE.

Terminal Block for Thermostat

Leave Jumper on, If Thermostat Is Not Used

Remove Jumper if Thermostat Is To Be Used

Jumper

Model T300P Series

(viewed from stove back)

Page 9