INSTALLATION
DAMPER ROD INSTALLATION
1.Locate rectangular cutout on bottom stove panel behind ash pan.
2. Screw damper rod into threaded hole.
DAMPER ADJUSTMENT
The damper rod is located under the bottom plate, on the right hand side of the stove, just behind the ash pan. It is very important to preset your damper prior to burning your pellet stove.
The damper plate contains nine notches spaced in 1/4” increments that aid in positioning (see Fig. A).
Fig. A
For initial setup, push the damper all the way in (when facing the front of the stove, “in” is to the left, and “out” is to the right) and slowly pull back three notches (see Fig. B).
Pulled Back
3 Notches
Fig. B
This setting should provide an adequate air to fuel ratio for most installations.
Page 8