WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
5.To Replace a Light Switch
Disconnect from electricity supply. Remove the control panel (see 3).
Note: The old switch may be destroyed during removal.
Remove the old switch from its bezel by gripping the switch body behind the control panel and twisting sharply. Remove the switch bezel by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the
Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.
Replace the Control Panel in reverse order and test for correct operation.
� | � |
| |
|
6.To Remove the Electronic Timer
Disconnect from electricity supply.
Remove the control panel (see 3). Pull off the timer control button(s).
Remove the timer/mounting bracket assembly from the control panel by removing the fixing screws.
Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.
Reassemble in reverse order. When replacing the leads, refer to the wiring diagram in this manual. Check the operation of the timer.
7.To Replace a Thermostat
Disconnect from the electricity supply.
Lift up the hob (see 2) and remove the control panel (see 3). Open the oven door. Remove the oven furniture and slide out the oven roof liner if fitted.
For the
For the
Feed the thermostat capillary out of the oven. Disconnect the wiring from the thermostat. Remove two screws holding thermostat to mounting panel. Fit new thermostat and reassemble in reverse order. Ensure that the phial is clipped to the oven back with the phial centrally positioned between the clips.
Check the operation of the thermostat.
8.To Remove the Grill Door
Remove the
23