REFRIGERATION FUNDAMENTALS
Refrigeration Access, Connections & Servicing
Assembly or disassembly and servicing to be accomplished by licensed refrigeration contractor.
•Refrigeration Unit slides directly out from lower section to allow for servicing.
•Service connections are located in the Refrigeration
•Refrigeration Unit is equipped with evaporator pan for case condensation. Insure evaporator pan is plugged in 110V receptacle inside base, and positioned under PVC drain and on base frame.
•When pulling or pushing unit in or out under the case, use caution to avoid damage to copper refrigeration lines, hoses and cable.
•Insure that the flexible drain hose is fully inserted into the slot of hose support for proper drainage. See illustration on next page for general location and specifics.
Temperature Control Module
•Temperature Control Module is located in the Electrical
•The temperature is controlled by the Temperature Control Module. It is located at
•If a temperature setting change is required, refer to the instructions for the CPC® (ESC3) Temperature Control Programming operating section of this manual
•Note: See Technical Data section of this manual for proper settings to maintain product temperature per model.
Temperature
Control
Module
Temperature
Control
Module
|
|
|
|
|
| Electrical |
|
|
|
|
|
| |
|
|
|
|
| r |
|
|
|
|
| t | fo |
|
|
|
| u |
|
| |
| eO |
|
|
| ||
id |
|
|
| g |
| |
Sl |
|
|
|
| Main Power | |
|
|
| icin | |||
|
| rv |
|
|
| |
Se |
|
|
| Switch | ||
|
|
|
|
|
| |
Light Ballast
R
888 Porter Rd. Muskegon, MI 49441 Phone: 231.798.8888 Fax: 231.798.4960 www.structuralconcepts.com
14